Invacare 1141466 - Manual (Page 2)

Walker Platform Attachment 2 Part No 1141466
Attaching the Walker Platform Attachment
ƽ WARNING
Ensure that the walker is securely locked in the open position before installing the walker plat-
form attachment - otherwise, injury may occur.
NOTE: For this procedure, refer to FIGURE 1.
NOTE: Reverse this procedure to remove the walker platform attachment.
1. Open the walker.
2. Determine which side of the walker the platform attachment will be used.
3. Loosen the adjustment knob on the upper clamp assembly (Detail “A”).
4. Open the clamp assembly and align it with the walker frame.
5. Close the clamp assembly over the walker frame and securely tighten the adjustment knob on the
clamp assembly.
6. Repeat STEPS 3 to 5 for the lower clamp assembly (Detail “B”).
Adjusting the Walker Platform Attachment Height
1. Loosen the adjustment knobs that secure the U‐clamps to the clamp assemblies (Detail “C”) and slide
the support tube up or down through the U‐clamps until the desired position is obtained.
2. Securely tighten the adjustment knobs after any adjustment.
FIGURE 1 Attaching/Adjusting the Walker Platform Attachment
Upper Clamp
Assembly
Adjustment
Knob
Adjustment
Knob
Lower
Clamp
Assembly
Walker
Frame
Front of
Walker
DETAIL “A” - UPPER CLAMP ASSEMBLY
DETAIL “B” - LOWER CLAMP ASSEMBLY
Adjustment Knob
Adjustment Knob
DETAIL “C”
Adjustment
Knobs
Support Tube
U-Clamps
Front of
Walker