Intermate Twinax Connection LX T-04 User Manual
Page 67
A p p e n d i c e s
I n t e r m a t e L X T - 0 4
67
2.
Make sure the Intermate LX T-04 is attached correctly to the printer. See
separate sheet for details about installing the interface.
Note:
If the LX T-04 was attached to the system and operating,
then the current address switch position represents the device
address assigned to the LX T-04. Write this number down
and save it.
3.
Set the address switch to position “9". This generates a test printout at
the next power On.
4.
Switch On the printer. The SYSTEM indicator flashes for a few
seconds.
5.
Study the test printout. It shows the firmware number and the default
settings. Note whether the ASCII character set is set to “PC-858", which
means Euro Support is active.
******** TEST PRINTOUT ********
Intermate LX T-04 version: K12-8491
Printer Driver #32 IBM Proprinter
IBM Printer Emulation__________ IBM 4214 model 2
System Language________________ 500 International Set 5
ASCII Char. Set________________ PC-858
6.
Switch Off the printer.
7.
Connect a terminal to the Intermate LX T-04 using the T-cable, and
switch the terminal On. The terminal should be terminated.
8.
Set the address switch to position “7" and switch On the printer. Wait a
few seconds after the SYSTEM indicator has stopped flashing.
9.
Select position “9". Wait until the SYSTEM indicator starts to flash.