Invacare 1085144 User Manual

Page 6

Advertising
background image

6

Installing the Bath Lift into the Bathtub
(FIGURE 9)

WARNING

ALWAYS lower the bath lift frame to the
lowest position BEFORE performing this
procedure. Otherwise, the bath lift frame
may tip during installation and injury or
damage may occur.

The frame MUST be placed into an
EMPTY bathtub.

1. Clean tub and wipe suction cups with a damp cloth.

2. Press the DOWN button on the pendant to lower

the bath lift to the lowest position.

3. Grasp the handgrip on the battery pack and pull

upwards to remove it from the motor shroud as
shown in FIGURE 9.

4. Place the frame into the bathtub.

5. Perform the following steps to position the frame

in the bathtub:

A. Position the rubber pads of the frame just in front of

the curve at the bottom of the back of the bathtub.

B. Install the seat. Refer to INSTALLING THE

SEAT in this instruction sheet.

C. Position the frame to align the line on the entry/

exit side flap with the inside edge of the bathtub
as shown in DETAIL "G" of FIGURE 9.

WARNING

The frame must be positioned so that
the side flap of the seat on the entry/
exit side of the bathtub is fully sup-
ported by the side of the bathtub. The
inside edge of the bathtub MUST be
aligned with the line on this side flap.

D. Ensure the rubber pads and suction cups are

positioned flat on the bottom of the bathtub.

NOTE: Pull up on suction cup loops to release suc-
tion cups from bathtub bottom.

6. Press firmly down onto the two (2) front suction cups

to attach the frame securely to the bottom of the bath.

FIGURE 8 - INSTALLING THE MOTOR SHROUD

Mounting

Bracket

Spade Connector Wire Wrap

Pendant

Cable

Mounting Screw

STEPS 2-3

Pendant

Secure Here

DO NOT Secure Here

Current

Limit

Device

STEP 2

BLACK Spade

Connector Wire

(STEP 1)

RED Spade

Connector

Wire

(STEP 1)

Nut

Mounting

Bracket

Mounting

Screws

Pendant

Secure Pendant

Cable and Spade

Connector Wire

Wrap Together

(STEP 2)

To Current Limit

Device

STEPS 1 - 3

Mounting

Holes

Upper

Spade

STEPS 4-6

Motor Shroud

Self-locking

Screws

Washer

Machine

Screw

Washer

Motor

Lower Spade

Advertising