IBM AS/400 - Manual (Page 71)

AS/400 Prompt
AS/400
Parameter
FBSS
Configuration
Display FBSS Prompt
LAN adapter address ADPTADR Token Ring
Communications PC address
If the AS/400 system uses a Token-Ring network line
to connect to the FBSS controller, values specified for
the FBSS and on the ADPTADR parameter on the
CRTLINTRN command must match.
If the AS/400 system uses an Ethernet line through
an 8209 LAN Bridge, see
″Appendix C: Local Area
Network Addressing Considerations ″ in the
Communications Configuration book.
Host/37xx/4700 address
If the AS/400 system uses a Token-Ring network line
to connect to the FBSS controller, values specified for
the FBSS and on the ADPTADR parameter on the
CRTLINTRN command must match.
If the AS/400 system uses an Ethernet line through
an 8209 LAN Bridge, see
″Appendix C: Local Area
Network Addressing Considerations ″ in the
Communications Configuration book.
Connection type CNN SDLC
Communications Switched line
Values specified for the FBSS and AS/400
configurations must match:
v If the FBSS response is Yes, CNN(*SWTPP) must
be specified for the CRTLINSDLC command and
SWITCHED(*YES) for the CRTCTLFNC command.
v If the FBSS response is No, CNN(*NONSWTPP) or
CNN(*MP) must be specified for the CRTLINSDLC
command and SWITCHED(*NO) for the
CRTCTLFNC command.
Destination service
access point DSAP Token Ring
Communications Service access point for PC
Values specified for the FBSS and for the DSAP
parameter on the CRTCTLFNC command must
match.
Duplex DUPLEX SDLC
Communications Line mode
Values specified for the FBSS and AS/400
configurations must match:
v If the FBSS response is Turn. required,
DUPLEX(*HALF) must be specified for the
CRTLINSDLC command.
v If the FBSS response is CRTS (Continuous request
to send), DUPLEX(*FULL) must be specified for
the CRTLINSDLC command.
Chapter 7. Communicating with remote workstation controllers 65