Inline Warehouse IN1124 - Manual (Page 6)

4
IN1124 / IN1130 Operation Manual - Preliminary 9/5/00 © 2000 - Inline, Inc.
The IN1124 local monitor output is not buffered. Therefore, the LOCAL
MONITOR OUTPUT Connector Port must be terminated, either with a local
monitor or the IN9031 VGA Termination Plug (included).
6.) Run the appropriate IN9500 Series CAT5 cable from the IN1124 to the IN1130.
Note: Always test your cable(s) prior to any permanent installation.
It is imperative that the wired pairs in the IN1124 / IN1130 CAT5 system
adhere to the wiring standards shown on the following page, otherwise the
system will not function properly. The pertinent standard for INLINE’s
CAT5 cable is the TIA 568B. In order for the IN1124 / IN1130 system to
function properly, the CAT5 wire pairs (regardless of their color) must be
maintained within both RJ45 connectors.
7.) Connect one end of the CAT5 cable(s) to one of the RJ45 Output Receptacles on the back of
the IN1124. Connect the other RJ45 connector(s) to the CAT5 Input Receptacle(s) on the
back of the IN1130 (s).
8.) Connect the IN1130 15-pin VGA output(s) to the display device(s).
9.) If applicable, connect the powered local speakers to the 3.5mm outlet(s) on the back of the
IN1130-2. Featuring (2) 3.5mm mini connectors for mono audio output, the IN1130-2 can
drive two pairs of speakers simultaneously, or be connected to any audio device that accepts a
buffered line level audio signal.
10.) Connect the round connector on the IN9204-1 / IN9204-2 power supply (included) to the
power input jack of the IN1130 (s) (located on the right side of the rear panel). Connect the
adapter box side of the power supply to the A/C power source. Both units power up
automatically after A/C power has been applied (the power indicator lights / front panel LEDs
will illuminate).
11.) Connect the round connector on the IN9211-1 / IN9211-5 power supply (included) to the
power input jack of the IN1124 (also located on the right side of the rear panel). Connect the
adapter box side of the power supply to the A/C power source.
12.) Turn on the computer, local monitor, all powered speakers and all remote data monitors.
13.) The IN1130 features a video peaking control (located on the right side of the back panel) that
enhances image detail and sharpness by boosting high frequencies, allowing users to optimize
the display device(s) video image for various cable lengths. Turning the regulator clockwise
will increase the peaking, and counter-clockwise will decrease the peaking. Using the
IN9333 adjustment tool (provided), gently adjust the peaking control until optimum
sharpness and picture quality is achieved.