Removing the rear cover – IBM 6274 User Manual
Page 51
Chapter 5. Installing options
37
Removing the rear cover
You must remove the rear cover to install internal options such as memory and
PCI adapters.
Attention:
Proper cooling is necessary to avoid damage to your computer. Do not
operate your computer without all covers in place.
To remove the rear cover, do the following:
1. Disconnect all cables attached to your computer. See “Disconnecting cables”
on page 36.
2. Place the computer on a padded surface in the position shown in the
following illustration.
Attention:
Be sure to use a soft, padded surface such as cloth or paper towels
when positioning the computer for service. The monitor or monitor bezel
might be scratched if placed on a hard surface.
3. Slide and hold latches 1; then pull and rotate the cover up until it clears the
base 2. Then remove the cover and put it in a safe place.