Invacare Fixed Released Rail/Cane Clamps - Manual (Page 3)

3
FIGURE 3- FIXED RELEASE CLAMPS FOR BACK
DETAIL “B”
Lock Washer
Sleeve
Mounting
Hook
Internal Mounting
Screw
Twist Release
Clamp
Fixed Release
Clamp
Mounting
Hooks
Seat Rail
Back Cane
Fixed
Portion
Inside of Back Cane
4. Install the quick release clamp onto the seat rail so
that the fixed portion is flush against and rests on top of
the mounting hook and the release portion is between
the front riggings and the mounting hook.
5. Reinstall the sleeve, lock washer, and internal mount-
ing screw into the quick release clamp and torque to
75 - inch pounds.
6. Repeat STEPS 1- 5 for other side.
7. Once quick release mounting clamps are secured, do
one (1) of following:
A. Refer to FIXED RELEASE CLAMPS FOR SEATin
PROCEDURE 2 of this instruction sheet.
B. Refer to USING CLAMPS in this instruction sheet.
Fixed Release Clamps For Seat (FIGURE 4)
NOTE: Refer to INSTALLATION WARNING in the
SAFETY SUMMARY before proceeding.
NOTE: The quick release and fixed release clamps are
designed to fit either 1-inch rail tubing or, with insert pro-
vided, 7/8-inch rail tubing.
1. Remove the sleeve, lock washer, and internal threaded
mounting screw from the fixed release clamp (DE-
TAIL “C”).
2. Place the fixed release clamp on the seat rail.
3. If fixed release clamp is not tightly fitted around seat rail
tubing, install insert provided as shown in DETAIL “C”.
4. Install the fixed release clamp onto the back rail so
that the fixed portion is flush against and rests on top of
the mounting hook and is located between the seat rail
and the bottom of the mounting hook.
5. Reinstall the sleeve, lock washer, and internal mount-
ing screw into the fixed release clamp and torque to
75- inch pounds.
6. Repeat STEPS 1-5 for other side.
7. Once fixed release mounting clamps are secured, do
one (1) of follow ing:
A. Refer to QUICK RELEASE CLAMPS FOR SEAT
in PROCEDURE 2 of this instruction sheet.
B. Refer to USING CLAMPS in this instruction sheet.
5. Reinstall the mounting screw, lock washer, and inter-
nal mounting screw into the fixed release rail/cane
clamp and torque to 75 - inch pounds.
6. Repeat STEPS 1 - 5 for other side.
7. Once fixed release mounting clamps are secured,
do one (1) of following:
A. Refer to QUICK RELEASE CLAMPS FOR
SEAT in PROCEDURE 2 of this instruction sheet.
B. Refer to USING CLAMPS in this instruction
sheet.
Quick Release Clamps For Seat (FIGURE 4)
NOTE: Refer to INSTALLATION WARNING in the
SAFETY SUMMARY before proceeding.
NOTE: The quick release and fixed release clamps are
designed to fit either 1-inch rail tubing or, with insert pro-
vided, 7/8-inch rail tubing.
1. Remove the sleeve, lock washer, and internal threaded
mounting screw from the quick release clamp (DE-
TAIL “C”).
2. Place the quick release clamp on the seat rail.
3. If quick release clamp is not tightly fitted around seat rail
tubing, install insert provided as shown in DETAIL “C”.