Ikelite DSC-P150 User Manual
Page 3
6
CChheecckkiinngg CCoonnttrroollss
Turn the camera on and operate each of the housing controls to
get a feel for using the camera in the housing Take a few
pictures above water with the camera in the housing
7
LLuubbrriiccaannttss
Ikelite provides silicone lubricant with the housing We recommend
you use only Ikelite lubricant on Ikelite products as some other
brands may cause the o’ring to swell and not seal properly
Use only enough lubricant to lightly cover control shafts and
o’rings Wipe off any excess lubricant with a clean cloth
Lubricant is not a sealant it is used to reduce friction Excessive
lubricant can collect sand and dirt which may interfere with
proper sealing
CCAAU
UTTIIO
ON
N
N
Neevveerr uussee sspprraayy lluubbrriiccaannttss aass tthhee pprrooppeellllaanntt iinnggrreeddiieenntt ccaann
ccaauussee tthhee ppllaassttiicc hhoouussiinngg ttoo ccrraacckk
8
D
Diiffffuusseerr &
& D
Deefflleeccttoorr IInnssttaallllaattiioonn
Housing shown with
Deflector installed
Deflector
9
D
Diiffffuusseerr aanndd D
Deefflleeccttoorr ccoonntt
A diffuser and deflector are
included with the housing The
diffuser is white transparent
plastic The deflector is also
white but is not transparent
and has a decal on the front
To install the diffuser or
deflector spread the port
clamp at the spring end
and slide over the lens port
The white plastic should be
placed in front of the camera
flash The port clamp should be
pushed back against the front
of the housing
D
Diiffffuusseerr
The diffuser should be installed when using the camera’s built in
flash When shooting with the camera’s built in flash at
approximately feet (
m) or less the lens port on the
housing may block a portion of the light from the camera’s
built in flash creating a shadow in the lower left of the photo
If this occurs zoom the lens slightly to eliminate the shadow
(You can test this above water)
D
Deefflleeccttoorr
The deflector should be installed when using an external strobe
such as the DS or DS Substrobe and EV Controller The
deflector will redirect the camera’s flash to the EV Controller
which controls the external strobes output
Diffuser/
Deflector
material
Port Clamp
Spring
Spread to Install
This edge
against
housing