Care and cleaning, Replacement of oven light bulb – Indesit KD6G25SWIR User Manual

Page 14

Advertising
background image

14

GB

! Never use steam cleaners or pressure cleaners

on the appliance.

!

Clean the glass part of the oven door using a

sponge and a non-abrasive cleaning product, then

dry thoroughly with a soft cloth. Do not use rough

abrasive material or sharp metal scrapers as these

could scratch the surface and cause the glass to

crack.

!

The accessories can be washed like averyday

crockery (even in your dishwasher).

! Switch off the electricity supply and allow to

cool before cleaning the cooker.

! Clean the cooker regularly and wipe up spills

soon after they occur to prevent them from

becoming burnt on. Never use biological

washing powder, caustic cleaners, harsh

abrasives, scouring pads, steam cleaners,

aerosol cleaners or oven chemical cleaners of

any kind.

! If it is necessary to remove the cooker for

cleaning, ensure that it is cool and beware that it

is heavy (approximately 70 kg 155 lbs).

Care and Cleaning

! To move the cooker forward, open the top oven/grill

door and with both hands positioned under the roof

of the compartment, lift and pull forward. Replace by

pushing the cooker backwards.

! Check that the cooker is level. Take care not to

damage any floor coverings.

REPLACEMENT OF OVEN LIGHT BULB

CAUTION: DISCONNECT THE APPLIANCE FROM

THE ELECTRICITY SUPPLY BEFORE

REPLACING THE LAMP TO AVOID THE

POSSIBILITY OF AN ELECTRIC SHOCK.

Light bulbs are not covered by the manufacturer's

guarantee.

A new 25W, 300°C rated SES bulb can be obtained

from your cooker supplier or any major electrical

retailer.

1. Remove the shelves from the oven.

2. Unscrew the lens using a thick cloth to protect your

fingers in the unlikely event of a lens fracture.

3. Unscrew bulb.

4. Fit new bulb and refit lens.

COOKER FINISH

CLEANING METHOD

Vitreous Enamel

Door inner panels, pan supports, burner caps,

roasting dish, grill pan, main oven base, inside of

grill compartment.

Cloth wrung out in warm soapy water. Stubborn stains can be

removed with a cream paste, liquid cleaner or by rubbing with fine

steel wool soap pads.

Check that the cleaning agent is approved by the Vitreous Enamel

Association.

Pain

t

Side panels.

Wash with a cloth wrung out in warm soapy water only.

DO NOT USE ABRASIVES.

Aluminium

Hotplate burner bodies, lid rear trim.

Similar to paint cleaning above. Use a nylon brush to remove any

cleaning materials, water or dirt from the hotplate burner bodies.

Glass

As for enamel cleaning. Polish with a clean dry cloth or kitchen roll.

Chromium Plating
Oven shelves, grill pan grid, grill pan handle

support.

Wipe with a cloth wrung out in warm soapy water. A fine steel wool

soap pad e.g. Brillo, Ajax, or a chrome or stainless steel cleaner

may be used.

Plastic
Grill pan handle, control knobs.

Wipe with a cloth wrung out in warm soapy water.

Stainless Steel
Hotplate, control panel.

Wipe with a cloth wrung out in warm soapy water. Polish with a

clean dry cloth or kitchen towel. For stubborn stains, use a

proprietary stainless steel cleaner and follow the instructions on the

container.

Advertising
This manual is related to the following products: