InFocus TD30 - Manual (Page 11)

10
Miscellaneous Function Adjustments
The following description is for the main signal source “Analog RGB”
Note: The text within the brackets relate to the same buttons on the remote control.
1. PICTURE
1-1 Brightness
Press and hold the MENU button until the OSD screen appears, and
press PROG▲▼ buttons to select Brightness, then you can easily
adjust the desired brightness with the VOL +/- buttons.
Note :
You may need to re-adjust brightness after the TD30 warms up. Too bright
of a setting could tire out your eyes easily.
1-2 Contrast
Press and hold the MENU button until the OSD screen appears, and
press PROG▲▼ buttons to select Contrast, then you can easily
adjust the desired contrast with the VOL +/- buttons.
1-3 Auto Picture
Press and hold the MENU button until the OSD screen appears, and
press PROG▲▼ buttons to select Auto Picture, then press the VOL
+/- buttons to perform automatic adjustment.
Note :
Perform the Auto Picture first after the installation is completed for the first
time.
Use the full and bright screen to perform Auto Picture. We recommend that
you should perform Auto Picture under a Windows environment, and doing
so can adjust the screen to the best display.
The Auto Picture function will disappear when the main signal source is
DVI