JVC Model GR-D244US - Manual (Page 21)

EN
21 VIDEO PLAYBACK
MasterPage: Start_Right
VI
DEO R
E
CO
RD
ING
& PLA
YBACK
A Yellow to VIDEO IN (Connect when your TV/
VCR has only A/V input connectors.)
B Red to AUDIO R IN*
C White to AUDIO L IN*
* Not required for watching still images only.
1
Make sure all units are turned off.
2
Connect the camcorder to a TV or VCR as
shown in the illustration.
If using a VCR, go to step 3.
If not, go to step 4.
3
Connect the VCR output to the TV input,
referring to your VCR’s instruction manual.
4
Turn on the camcorder, the VCR and the TV.
5
Set the VCR to its AUX input mode, and set
the TV to its VIDEO mode.
6
Start playback on the camcorder. ( ੬ pg. 20)
To choose whether or not the following
displays appear on the connected TV
● Date/Time
Set “DATE/TIME” to “AUTO”, “ON” or “OFF”.
(
੬ pg. 22, 27)
● Time Code
Set “TIME CODE” to “ON” or “OFF”.
(
੬ pg. 22, 27)
● Indications other than date/time and time code
Set “ON SCREEN” to “OFF”, “LCD” or “LCD/TV”.
(
੬ pg. 22, 27)
NOTES:
● It is recommended to use the AC Adapter as
the power supply instead of the battery pack.
(
੬ pg. 13)
● To monitor the picture and sound from the
camcorder without inserting a tape, set the
camcorder’s Power Switch to “A” or “M”, then set
your TV to the appropriate input mode.
● Make sure you adjust the TV sound volume to its
minimum level to avoid a sudden burst of sound
when the camcorder is turned on.
Connections To A TV Or VCR
2 1 3
TV
VCR
Open the cover.
To AV
connector
Audio/Video
cable
(provided)
GR-D244US.book Page 21 Tuesday, May 31, 2005 2:37 PM