JVC KM-H3000E - Manual (Page 18)

12
To configure a static IP address for your switcher:
1. Ensure your switcher is connected to your
network via the ethernet port.
2. Press MENU.
3. Press the SYSTEM Wipe Pattern button.
4. Press NEXT until IP Addr is displayed.
5. Press the IP Addr knob to display the IP
Address menu.
6. Use the IPMode knob to select Static.
7. Press the IPMode knob to enter the selection.
8. Press the Confrm knob to commit the change.
Press the Cancel knob to discard the change
and return to the previous setting.
9. Press NEXT until IPAddr is displayed.
10. Use the left knob to select the data to configure.
You can choose from the following:
• IPAddr — Configure the IP address (configure
this first).
• Mask — Configure the network mask.
• Gatwy — Configure the default gateway.
11. Use the middle knob to select the fields in the
address.
12. Use the right knob to modify the field value.
13. Repeat steps 9 to 12 for Mask (network mask),
and Gatwy (network gateway).
14. Press the left knob to save all network settings.
15. Press the Confrm knob to commit the change.
Press the Cancel knob to discard the change
and return to the previous setting.
Switcher Personality
The switcher has customizable features that allow
you to tailor operation to your personal preferences.
Aux Bus Memory Recalls
You can set the behavior of the Aux buses during a
memory recall. The buses can be configured to hold
inputs (overriding whatever input is saved in the
recalled memory) or to change to the input saved in
the recalled memory.
To set the Aux Bus Recall Mode:
1. Press RECALL.
2. Press NEXT until AuxMem is displayed.
3. Press the AuxMem knob to set the Aux Bus
Recall Mode. You can choose from the following:
• NoRcll — Aux buses ignore the input saved
with the recalled memory and retain the
current input.
• Recall — Aux bus inputs change to the input
saved with the recalled memory.
For More Information on...
• saving and recalling switcher settings, refer to the
section “Using the Memory System” on page 23.
Customizing the Panel Glow
Panel buttons are set to a glow color which is used
when the button is not selected. This glow color can
be customized to your preference.
To customize the Panel Glow color:
1. Press MENU.
2. Press the USER Wipe Pattern button.
6 5
3
4
2
10 11 12
9
3
2
1
3 4 5
2
1