JVC KM-H3000E - Manual (Page 32)

26
3. Press the Limit knob.
The Progress Bar next to the Fader flashes to
indicate the defined transition limit.
Note:
• Ensure that you are not on-air when setting the
transition limit as you will be moving the Fader
handle to define the preset position.
To perform a transition with a transition limit set:
1. Initiate a transition by pressing AUTO TRANS.
When the transition reaches the defined limit, it
will stop.
2. To reverse the transition, press AUTO TRANS.
3. To continue the transition, press the Limit knob
to turn off the transition limit.
4. Press AUTO TRANS to complete the transition.
To Quickly Reset the Transition Limit
• Double-press the Limit knob.
The transition limit is reset to 50% and the
trans limit feature is turned off.
Reset Options
You can restore the entire switcher or individual
settings to default values. Menu items can also be
reset.
You can also capture the state of the switcher as a
user-defined default, allowing you to reset to those
settings at any time.
You switcher is shipped with the following default
settings:
• The selected source on each bus is black.
• Each key is set to Auto-Select.
• Clip is set to linear.
• Gain is set to linear.
• The Transition Limit is cleared.
• Keys are off-air.
• The Matte is set to Hue: 30.5%, Sat: 100%, Lum:
50% Size: 0.0%.
• The Wash turned off.
• The selected Wipe pattern is the STATUS wipe
pattern button.
• Wipe parameters are defaulted
• The Next Transition is set to dissolve.
• Masks are turned off .
• The Fader is disabled if it is off limit.
• The main Transition rate is set to:
› 15 frames for 59.94 Hz video formats.
› 13 frames for 50 Hz video formats.
• The Key Transition rate is set to:
› 8 frames for 59.94 Hz video formats.
› 7 frames for 50 Hz video formats.
• The Chroma Key is set to Edge: 0.0%, Shadow:
100.0%, Gain: 100.0% Spill: 0.0%.
• The Output Sync is turned off.
• The Frame Sync is turned off
• The Power Save timeout is set to 20 minutes.
Note:
• Default transition rates vary depending on the
frequency of the selected video format.
Configuring Default Settings
You can customize any of the default parameters and
save them as a user-defined default.
To configure user-defined defaults:
1. Configure any of the settings in the previous list
as desired. This will become the new default
state.
2. Press MENU.
3. Press the RESET Wipe Pattern button.
3
1
5 4
3
2