JVC AV 27020 - Manual (Page 13)

I N I T I A L S E T U P 1 3
AUTO TUNER SETUP
During Auto Tuner Setup, the TV w i l l
automatically scan through all available
channels and memorize the active ones
so that when you scan, you do not pick
up weak or noisy channels.
Press the M ENU button
To AUTO TUNER SETUP
To operate
To choose CABLE or AIR
To move to START
To start Auto Tuner Setup
The Programming takes approximately
1 to 2 minutes
Note: Noise Muting will not work while
Auto Tuner Setup is working.
NOW
PROGRAMMING!
48
TUNER MODE : CABLE AIR
START
PROGRAMMING OVER!
CHANNEL SUMMARY
You can add or delete channels from the
channel scanning. You can also lock out
any “unauthorized” viewers from one or
up to all 181 channels.
Press the M ENU button
To CHANNEL SUMMARY
To operate
ADD
You can manually set channels to scan
that were too weak to be picked up
during Auto Tuner Setup. (If you have not
performed the Auto Tuner Setup, in
previous column, do so now.) Conversely,
if a channel was too weak to receive a
good picture but was picked up anyway,
delete it by removing the
X .
To the ADD column
To include or delete from scan
E XIT when finished
Note: Channels set to scan will be
marked with an X.
Note: Some cable systems experience
interference from radio frequencies on
Cable Channel 95. You can delete this
channel f rom scanning by removing the X.
CH ADD : CH ADD
0 1 – – : 06 X –
0 2 X – : 07 – –
0 3 X – : 08 – –
0 4 X – : 09 X –
0 5 X – : 10 X –
Continued next page ...
NOTES:
During Initial Setup,
the TV will be
programmed to
only receive active
channels. Once the
channels are
activated by the
Auto Tuner Setup
they will be includ-
ed in Scan.
Some weak
channels may be
included or omitted
during this
procedure. You can
add or delete any
channels for
scanning in the
Channel Summary.
Noise Muting will
not work while you
operate the
Channel Summary.