JVC 0207TNH-II-IM - Manual (Page 40)

40
Auto Tuner Setup
The auto tuner setup function is described on page 23 as the interactive plug-in menu. If you
need to run the auto tuner setup again, follow the steps below.
Press the M ENU button
π† To "Tuner Setup"
è To enter
π† To "Auto Tuner Setup"
è To enter
è To choose "Cable" or "Air"
π† To "Scan Mode"
è To choose "Auto", "STD", "HRC" or "IRC"
† To "Start"
Press the O K button (Programming will take serveral minutes)
The auto tuner is finished when the message "Programming Over !" appears onscreen.
Tuner Setup > Auto Tuner Setup
Tuner Mode
Scan Mode
Select BACK Back MENU Exit
Air
Auto
Operate
– +
Start
Notes:
• When the Tuner Mode is set to "Cable", it is possible to select "Scan Mode"
• If no channels were found using Auto Tuner Setup, check your antenna cable and the
settings for Tuner Mode/Scan Mode.
• You can also access the "Front Menu" screen by using the M ENU button on the side of the
TV instead of the remote control. It has "Video Status", "Aspect", "Auto Tuner Setup" and
"Menu". Choose "Auto Tuner Setup" by pressing M
ENU † on the side panel and enter by
using the C HANNEL +/- buttons ( √ OPERATE ® ).
Tuner Setup
LCT2224-001B-A English.indd 40 LCT2224-001B-A English.indd 40 2/20/07 9:25:36 AM 2/20/07 9:25:36 AM