GE 24908 GE Universal Remote - Manual (Page 10)

10
Programming With Code Search
If your TV, VCR, DBS Satellite System or Cable Box does not
respond after you have tried all the codes for your brand, or if your
brand is not listed, try searching your code by following the steps
below:
1. Manually turn on the device you wish to program.
2. Press and hold the
CODE SEARCH until the
INDICATOR LIGHT lights, then
release CODE SEARCH.
3. Press and release the
device button for the device
you are programming. The
INDICATOR LIGHT will blink
once, then remain lit.
4. Press and release OFF•ON
until your device turns off.
5. When your device turns off,
press ENTER, the INDICATOR
LIGHT will turn off.
IMPORTANT: you may have to
press OFF•ON up to 200 times.
Identifying Codes
From Your Universal
Remote
INDICATOR
LIGHT
BLINK
OFF
Retrieving Codes
If you need to find the three-digit code for your TV, VCR, DBS or
Cable Box after your device is set-up, use this procedure.
1. Press and hold CODE SEARCH
until the INDICATOR LIGHT
lights, then release CODE SEARCH.
2. Press and release the device but-
ton for the code you are retrieving.
The INDICATOR LIGHT will blink
once.
3. Press and release
CODE SEARCH. The INDICATOR
LIGHT will turn off.
4. Starting with 0 on the keypad,
press the number buttons in order
(0-9) until the INDICATOR LIGHT
blinks.
5. The number which causes the
INDICATOR LIGHT to blink is the
first digit of your code.
6. Repeat Step 4 until you have
retrieved all three numbers in the
code.
INDICATOR
LIGHT
OFF
...