JVC XL-PM6S - Manual (Page 2)

6 5
8 7
XL-PM6S/XL-PR70B / LVT1297-004A / B
XL-PM6S/XL-PR70B / LVT1297-004A / B XL-PM6S/XL-PR70B / LVT1297-004A / B
4
3
VOLUME
6
VOLUME
1
5
R L
OFF ON
HOLD
2
00 1 02 53 01 001 02 53
MP3 WMA
Button Operation
To pause
To stop
To turn off the
unit
Fast forward/
reverse
Group skip
(MP3/WMA only)
(XL-PR70B only)
To switch over
the mode from
FM to CD
Display/reference
00 7 00 18 01 00 4 00 07
01 0 44 48 1 0 03 5
Skip function
During play,
Search function
Keep depressed during play.
• Play stops automatically when all the tracks have
been played.
• (XL-PR70B) Press this button again when the FM
(Tuner) reception mode becomes active.
For your reference:
“DISC”
This indication appears if 3/8 is pressed when no disc is loaded
or if the disc is not properly seated.
“READING”
Preparation period before playing the track.
Appears for several seconds after pressing
3/8 to play.
“OPEN”
This indication appears when the lid is open.
Removing discs
Turn off the unit and, after the disc has stopped rotating, remove
the disc as shown below:
Auto power off
If the unit is left in stop mode for 30 seconds, the unit turns
itself off automatically to prevent the batteries from running
down.
Auto power off function does not work when the source is
FM.
Disc rotation noise
The portable CD player uses a power-saving operation method
so that disc rotation noise will intermittently be emitted. But, it
is not a failure.
• To skip back to the previous track, quickly press 4
twice.
• During Program play, the button is used to fast for-
ward or back through the programmed sequence of
tracks.
• During Random play, the skip button cannot be used
to skip back to tracks that were played previously in
the random sequence.
During play,
During play,
Reverse
Basic Play
Label side
Elapsed playing
time of each track
No indication
WMA can be played back only with XL-PR70B.
Follow the steps in the numerical order.
Track number
in play
Firmly connect
Forward
While stopped,
Press again to restart play.
HBS
Lights when a
MP3/WMA disc is
used
Group
number
Track number (in the group) in play
For MP3/WMA For Audio CD
Elapsed playing time of
each track
Audio CD MP3/WMA
Total number of tracks
Total playing time
Total number of groups
Total number of tracks
Group number
0 2 00 1
GROUP UP
GROUP DOWN
During play or while stopped,
Intro play
You can successively play the first 10 seconds of every track.
1 While stopped,
MODE
INTRO
2
To cancel
Press MODE repeatedly until “INTRO” goes out.
Notes:
• You can also select Intro play during playback.
In this case, Intro play will start from the next track after the
current track has finished.
• You can also select Intro play during Program play mode.
Random play
During playback,
MODE
RND
After playing all tracks, the unit stops.
To cancel
Press MODE until “RND” goes out, or press 7 to stop the disc.
Notes:
• You can also select Random play in stop mode.
• During Program play, you can not select Random play.
Repeat play
You can repeat one track or all tracks.
During playback,
MODE
GRP
ALL
To cancel
Press MODE repeatedly until the repeat indicator goes out.
Notes:
• You can also select Repeat play during Program play.
• You can also select Repeat play while stopped.
Program play
You can program up to 64 tracks in any desired order including
the same tracks.
For Audio CD, go to step 3.
Though the display differs a little, operation is the same.
1 While stopped,
(MP3/WMA only)
00 000 P-01
PROGRAM
2 (MP3/WMA only) Select the desired group
number. (e.g.02)
02 00 1 P-01
GROUP UP
GROUP DOWN
3
PROGRAM
02 0 01 P-01
4 Select the desired track.
02 0 03 P-01
5
00 0 00 P-02
PROGRAM
PROG
The track is registered.
6 For MP3/WMA, repeat steps 2-5 to select other
tracks.
For Audio CD, repeat steps 4 and 5.
When you program exceeding 64 tracks, the program se-
quence number returns to “01” and will overwrite the previ-
ous setting.
7
• To confirm the program
While stopped, press PROGRAM repeatedly. At this time, you
can add and change the program, if required.
• To delete the entire program
• While stopped, press STOP.
• Turn off the unit.
• (XL-PR70B) Change the source to FM.
Hyper-Bass Sound effect
You can enjoy powerful bass sound.
OFF 2 1
HBS
Anti-Shock Protection EX
This function achieves excellent performance against sound inter-
ruption caused by vibrations. You will be able to enjoy listening
to music during (not vigorous) jogging.
By utilizing the high-performance servo circuit, audio data will be
stored in the memory ahead of time.
For Audio CD:
Up to 40 seconds worth (Anti-Shock Protection
on/off selectable)
For MP3/WMA: Up to 100 seconds worth at 128 kbps (Anti-
Shock Protection is fixed to on.)
Normally, this function is in effect.
ASP
As the audio data is gradually stored, the indicator changes as follows:
ASP ASP
To cancel
(Audio CD only)
A.S.P
The “ANTI SHOCK” indicator goes out.
To activate again (Audio CD only)
Press A.S.P.
Notes:
• During this operation, the disc rotates at a higher rate than usual
in order to collect extra audio data. This may cause the batteries
to run out faster and could result in a slight increase in disc rota-
tion noise.
• This function can be switched ON and OFF during playback.
However, this may cause a slight interruption in the sound be-
cause the disc’s rotational speed changes.
Preventing Accidental Operation (Hold
mode)
This function causes the unit to ignore, accidental button presses.
Hold mode prevents the following:
• Powering on the unit accidentally (which can cause the batter-
ies to go dead).
• Play being cut off unexpectedly.
To use the Hold mode
OFF ON
HOLD
• To prevent the unit from powering on accidentally, set the
HOLD switch to the ON position while the unit is turned off.
• To prevent the unit from unexpected operation during play, set
the HOLD switch to the ON position after you starts playing
the disc.
• When the unit is in Hold mode, ”HOLD” and “ ” light as
follows.
Power on : “
” stays lit.
Power off : “HOLD” and “ ” light up for a few seconds
when 6 is pressed.
Notes:
• Before turning on the unit, be sure that HOLD is OFF.
Otherwise, you cannot turn on the unit.
(Repeatedly)
Other Play Methods
(Repeatedly)
(Repeatedly)
Program sequence number
Track number
Group number
ANTI SHOCK
indicator
[Fully stored]
Tuner Operation (XL-PR70B only)
You can listen to FM stations by tuning in manually, automati-
cally, or using preset memory.
For best reception, extend the headphone cord (antenna).
Manual/Auto tuning
1
FM
107.00 MHz
When the power is turned on and you want to change the mode
from CD to FM, keep the button depressed.
When the power is turned off, press the button.
If the CD mode becomes active, keep the button depressed to
switch over the mode to FM.
2 Select a station.
Manual tuning
Press ¢ or 4 repeatedly to select a station you want.
Auto tuning
Hold down ¢ or 4 for a while and then release it. The fre-
quency automatically changes up or down to find the next station.
Presetting stations
You can preset up to 20 stations (frequencies).
1 Select the station you want to preset.
Use Manual or Auto tuning mentioned earlier.
2
PROG
PRESET FM
PROGRAM
1 107.00 MHz
3 Select the preset number (01~20) you want.
PROG
PRESET FM
8 107.00 MHz
GROUP/PRESET
UP
DOWN
4 Press PROGRAM.
Preset tuning
Select the preset number you want in the FM
reception mode.
GROUP/PRESET
PRESET FM
8 107.00 MHz
UP
DOWN
Preset number
“MONO” appears.
Preset number
Preset station
Changing the FM reception mode
When a broadcast is in stereo, “ST.” lights up and you can hear
stereo effects. However, if an FM stereo broadcast is hard to re-
ceive or noisy, you can select monaural (MONO) mode. Recep-
tion improves, but you lose the stereo effect.
To select the monaural mode
FM MONO
107.00 MHz
MODE
To cancel the monaural mode
Press MODE once again. “MONO” will go out.
The monaural mode is cancelled also by changing the frequency.
Turning off the unit
MP3/WMA File Compatibility
• This player can read MP3/WMA files that are recorded in the format that is compliant with ISO
9660.
• The player can read or play an MP3 file with the extension code —“.mp3” and a WMA file with the
exrension code — “.wma”.
• Track title can be displayed.
• ID3* tags can be shown on the display.
* An MP3/WMA file can contain file information called “ID3 Tag” where its album name, artist, title,
etc. are recorded.
Playing order of MP3/WMA files
The illustration below shows the normal playing order of the MP3/WMA files. You will see that the
MP3/WMA files are played back in the order from the higher hierarchy to the lower one.
3
4
9
8
10
6
7
1
2
5
About MP3/WMA files
Hierarchy
Reverse
Forward
1 track repeat 1 group repeat
(MP3/WMA only)
All track repeat
Group
MP3/
WMA file
(ID3 tag)
In FM mode,