Jwin JX-CD4000 - Manual (Page 8)

Manual tuning
* To tune to weak stations, use manual tuning by pressing TUNING UP/DOWN button continuously until
you read the correct frequency or the reception is at its best.
* When the STEREO appear on the display, you are receiving a FM stereo transmission. (FUNCTION switch
must be at RADIO/FM ST. position.)
STORING STATION
1. 30 stations can be stored in memory, you can tune in the stored station directly by pressing M-UP button.
2. Set the FUNCTION switch to RADIO function
3. Select your desired band.
4. Tune in the desired station.
5. Press MEMORY button, LCD display “MEMORY”.
6. Select location number 1 to 30 of preset station by pressing the M-UP button and press “MEMORY”
button again.
7. Repeat above steps 2 to 5 for each station stored.
8. By listening back the Preset Station, Press M-UP button.
Note :
1. You can not erase a previously stored station, but storing a new station will exchange the previous one.
2. If no power supplied, then stored station are erased. Please store station again.
Cassette deck
Inserting a cassette
*
Press STOP/EJECT button on deck, the cassette door opens.
* Insert a cassette tape into the compartment with the open side downwards and the full spool on the left.
* Close the cassette door.
Recording from other sound sources
* Press TUNER/CD to select the sound source.
* Place a cassette tape in DECK.
* Press RECORD, in doing so, PLAY is pressed too, to start the recording. When the tape has reached its
end, the tape stops.
* To interrupt a recording, press PAUSE.
* To continue recording, press PAUSE again.
* Press STOP/EJECT if you want to stop the recording before the end of the tape.
Playback of cassette
* Set the unit to TAPE mode by sliding the FUNCTION Switch. TAPE will appear on the display.
* Place the cassette tape in deck.
* Press PLAY on the unit to start playback.
Playback stops when the tape reaches the end.
* For brief interruptions, press PAUSE on the unit to continue playback, press PAUSE again.
* Press STOP/EJECT if you want to stop playback the end of the tape.
Winding the tape
* Press F.F to fast-forward the tape.
* Press REW to fast-rewind the tape
* Press STOP/EJECT to stop fast-forward or fast-rewind, before the end of the tape.
UK-6