Jensen JISS-300I - Manual (Page 11)

10

After all the programmed tracks have been played, the player stops but the programmed tracks
remain in the memory.

Press the PROGRAM Button followed by the PLAY/PAUSE Button to begin programmed
playback again.
7. To cancel programmed play, in Stop mode press the STOP
■
Button once or open the CD DOOR.
8. To turn the CD player off, set the FUNCTION selector to STANDBY/AUX position. The LCD
backlight will go off.
LISTENING TO YOUR iPod/iPhone
1. Gently push the iPod/iPhone compartment door to open it. The door will automatically open.
2. Place your iPod/iPhone into the docking port by placing the connector on the bottom of the
iPod/iPhone onto the connector in the docking bay. When the system is powered by AC,
iPod/iPhone battery charging will start automatically even if the Dock is in standby mode.
Note: (1). Please be careful when seating the iPod/iPhone into the docking to avoid damaging the
30-pin connector on the iPod/iPhone or in the Docking System. Dock your iPod/iPhone
carefully into the 30-pin connector and then close the door.
(2). The iPod/iPhone will only be charged when the System is powered by AC.
3. Close the iPod/iPhone compartment door, set the FUNCTION selector to the iPod/iPhone position,
the LCD backlight will light and display the message “iP”.
4. Press the PLAY/PAUSE button to start play back.
5. Select the previous or next music tracks by pressing the B-SKIP
 or F-SKIP  Buttons
repeatedly, and press the PLAY/PAUSE Button to play or pause.
Note: The System’s LCD will not show any music information (e.g. song name) for your
iPod/iPhone. Please view the music information through your iPod/iPhone display.
6. Adjust the sound level using the VOLUME control.
Note: The volume level cannot be adjusted using the volume control on your iPod after docking.
7. To remove the iPod/iPhone from the unit, press and hold the PLAY/PAUSE Button on the
System for a few seconds to switch off the device, open the iPod/iPhone compartment door and
then gently remove it from the dock connector.
8. To turn the iPod/iPhone mode off, set the FUNCTION selector to STANDBY/AUX position. The
LCD backlight will go off.
iPod/iPhone playback control:

Press the iPod/iPhone PLAY/PAUSE button to pause or resume the iPod/iPhone
playback;
 Press the SKIP or buttons to skip to the next or previous song;
 Press and hold the SKIP or buttons for fast-forwarding or fast-rewinding during
playback.
 From the remote, press the MENU button, ENTER button and / buttons on the remote