JVC XV-D2000BK - Manual (Page 54)

52
XV-D2000BK
LET0091-001A
Controlling Other Equipment
Controlling CATV
converter or satellite
tuner
To change the Remote Control signals for operating a CATV converter or satellite
tuner
1. Set the DVD/TV/CATV selector to the “CATV” position.
2. Press and hold POWER-CATV/SAT, then press SET.
Do not release POWER-CATV/SAT. Keep holding POWER-CATV/SAT until the
next step is completed.
3. Holding POWER-CATV/SAT, enter the manufacturer’s code (two digits) using
numeric buttons 1-9, and 0.
See the lists on page 61 to find the manufacturer’s code.
4. Release POWER-CATV/SAT.
The following buttons can be used for operating the CATV converter or
satellite tuner (with DVD/TV/CATV selector set to “CATV” position):
• POWER-CATV/SAT: Turns on and off the CATV converter or satellite tuner.
• CH +/-:
Changes the channels.
• 1-9, 0: Selects the TV channels. (See “How to use numeric keys”
on page 17)
Note: Refer also to the manual supplied with your CATV converter or satellite tuner.
5. Try to operate your CATV converter or satellite tuner by pressing POWER-
CATV/SAT.
If your CATV converter or satellite tuner turns on or off, you have entered the
correct code.
Note: If there is more than one code listed for your brand of CATV converter or
satellite tuner, try each one until the correct one is entered.
Controlling a JVC
amplifier or receiver
DVD CATV TV
SET
1 2 3
4 5 6
7 8 9
10 0 10 +
100+ CH RETURN
CATV/SAT TV DVD
POWER
CATV/SAT TV DVD
POWER
CATV/SAT TV DVD
POWER
AUDIO VOLUME controls the volume of a JVC amplifier or receiver.
XV-2000BK/3E 9/24/97, 1:31 PM 52