Jims USA Twin Cam Racekit Box 1 1208-1351 User Manual
Page 6
555 Dawson Drive, Camarillo, CA 93012 Phone 805-482-6913 • Fax 805-482-7422
5
Rev I
9-12
No.1208-1351
A Division of Thiessen Products, INC
IIn
ns
st
tr
ru
uc
ct
tiio
on
n S
Sh
he
ee
et
t F
Fo
or
r B
Bo
ox
x 1
1 1
12
20
0”
”,, 1
13
31
1”
”,, o
or
r 1
13
35
5”
”
E
En
ng
giin
ne
e A
As
ss
se
em
mb
bl
liie
es
s O
Or
r E
En
ng
giin
ne
e R
Ra
ac
ce
e K
Kiit
ts
s
Oil Filter Mount for Engine “A” 99-06 FL, 99-05 FXD
•
Remove from package and inspect for debris and imperfections.
•
Verify the package includes three (3) bolts with washers and one (1) locking flange.
•
Check that there are two o-rings present.
Tools necessary for box 1 installation: See Fig.4
❏
3/8” drive torque wrench 5-75 ft/lbs
❏
3/8” drive torque wrench 40-200 In/lbs
❏
3/8” drive ratchet
❏
7/8” deep socket
❏
1/2” 12 point socket
❏
7/16” socket
❏
6” caliper
❏
“A” TC Engine Stand, JIMS
®
No.1022
❏
“B” TC Engine Stand, JIMS
®
No.902
❏
Small brass punch, JIMS
®
No.1081
❏
Small brass hammer, JIMS
®
No.1080
❏
20W - 50 clean H-D
®
engine oil
Recommended Tools & Supplies
❏
A small tooth brush
❏
Several lint free cloths
❏
A flashlight
❏
One quart 20W-50 H-D
®
Motor Oil
The following are required to install the cylinder studs:
❏
The furnished six long and two short studs.
❏
The furnished Loctite compound 620.
❏
One (1) furnished cylinder dowel pin tool (1/4” x 1/2”)
❏
One (1) furnished Short Head bolt
❏
A solvent to degrease the threads of each stud. Use Loctite primer, ace
tone, denatured alcohol, rubbing alcohol or other non-residue solvent
for this purpose.
❏
Preminum grade Moly Lube with rust and corrosion inhibitors.
Follow all chemical manufacturer’s instructions and heed all warnings spe-
cific to each chemical used.
Fig.4 - Tools Required
Alpha Engine
stand shown
use on 99’-10’
JIMS No.1022
Beta Engine Stand
JIMS No.902 Use on all Betas