Jensen HD5212 - Manual (Page 12)

8
HD5212
Operation
Power
Press the (power) button (1) or any other button on the front of the radio
(except release) to turn the unit on. Press and hold the power button to turn
the unit off.
Liquid Crystal Display (LCD)
The liquid crystal display (LCD) panel (8) displays the frequency, time and
activated functions of the unit, including a disc indicator, which appears lit
when a disc is inserted.
Press the (power) button (1) to change the LCD backlight brightness from
HIGH (default) to MIDDLE to LOW.
NOTE: LCD panels may take longer to respond when subjected to cold
temperatures for an extended period of time. In addition, the visibility
of the numbers on the LCD may decrease slightly. The LCD display
will return to normal when the temperature increases to a normal
range.
Mode
Press SRC (2) to select a different mode of operation, as indicated on the
display panel. Available modes include HD RADIO/TUNER (F1, F2, F3,
AM1, AM2), SAT RADIO (if connected), CDP PLAY (CD), USB PLAY, SD
PLAY, iPod (if connected) and AUX (auxiliary). CDP mode appears in the
menu only if a CD is present in the CD player.
NOTE: CDP PLAY, USB PLAY, SD PLAY, satellite radio and iPod modes
are only available if the associated device or media is inserted.
Audio Mute
Press the MUTE button (6) to silence the audio volume. “MUTE” flashes in
the display. Press any button to cancel MUTE.
Volume / Audio Control
To increase the volume, rotate the rotary encoder (4) clockwise. To
decrease the volume, rotate the rotary encoder counter-clockwise. When
volume is adjusted, the volume level will be shown on the display panel as a
number ranging from “VOL 00” (lowest) to “VOL 100” (highest).
Press the rotary encoder repeatedly to step through the following audio:
VOLUME, BASS, TREBLE, BALANCE, and FADER. The unit automatically
exits audio control mode after five seconds of inactivity.
BASS
To adjust the bass level from “-10” to “10”, press the rotary encoder until
“BAS” appears on the display. Rotate the control clockwise to increase or
counter-clockwise to decrease the bass. “00” represents a flat response.
TREBLE
To adjust the treble level from “-10” to “10”, press the rotary encoder until
“TRB” appears on the display. Rotate the control clockwise to increase or
counter-clockwise to decrease the treble. “00” represents a flat response.
BALANCE
To adjust the balance from “10L” (full left) to “10R” (full right), press the
rotary encoder until “BAL” appears on the display. Rotate the control to
adjust the balance between the left and right speakers. “L=R” represents a
center balance.
FADER
To adjust the fader from “10F” (full front) to “10R” (full rear), press the rotary
encoder until “FAD” appears on the display. Rotate the control to adjust the
fader between the front and rear speakers. “F=R” represents an equal
balance between the front and rear speakers.
PRESS
RPT SHF SCN 1 2 3 4 5 6
SEL
CAT/DIR AUX IN
MONO DISP EQ
BAND
SRC
TUNE/CH
MUTE
A~Z
0~9
PS
ENTER
IPOD
FILE/FOLDER HD5212 SAT
READY
1 2 4 7
10
11
3
5 6 8 9 20
12
19 21
13 14 16 15 17 18 22