Two-piece shaft, Bevel gear, Maintenance – Jonsered GC 2125C User Manual

Page 25

Advertising
background image

English

– 25

MAINTENANCE

Two-piece shaft

(GC 2125C)

The drive shaft end in the lower shaft should be lubricated
with grease every 30 hours. There is a risk that the drive shaft
ends (splined coupling) on models with two-piece shafts will
seize if they are not lubricated regularly.

Bevel gear

The bevel gear is filled with the right amount of grease at the
factory. However, before using the machine you should check
that the bevel gear is filled 3/4 full with grease. Use
JONSERED special grease.

The grease in the bevel gear does not normally need to be
changed except if repairs are carried out.

Advertising