Jack Lananne's Power Juicer power juicer - Manual (Page 14)

The motor does not
run after being
switched on.
The motor is running
with loud noise and
shaking.
The motor overheats
causing the power
to automatically
shut off.
The Motor is spinning
and processing fruit/
vegetables but nothing
is coming from spout.
Juice is leaking from the
receptacle but nothing
is coming from the spout.
The unit is assembled
but the motor will not
spin when power is
turned on.
Juice splashes from the
rim of the receptacle.
• Check to see if unit is plugged in.
• Locking bar is not locked in place properly.
• Check if all parts are assembled properly.
• Check if there is any residue left between blade and
receptacle.
• Press reset switch located on the underside of main base.
• Check that all parts are assembled properly and in the
correct position.
• Juicing overripe fruit may result in too much pulp and will
clog the filter. Turn machine off and clean the filter.
• The motor needs to warm up for 10 seconds before use.
• The fruits and vegetables may be soft or overripe.
• There may be too much pulp in the filter. Turn machine off
and clean the filter.
• Motor stops running due to the built-in feature, the
overheat safety control.
• Press reset switch located on the underside of main base.
• Check silver bar is in the upright position
• Check the spout to make sure it is in the downward
position.
• Check the pulp collector to make sure it is properly
assembled. If it is not properly assembled it will activate
the Micro Safetyswitch and the motor will not operate.
• Press reset switch located on the underside of main base.
• Check that the juice spout is in the downward position.
If the juice spout is left in the upright position the juice
will not flow. It will stay in the receptacle and may overflow
from the sides.
• This is normal.
Problem Possible Reasons and Solution
Troubleshooting
14
Troubleshooting
POWER JUICER ELITE
Replacement
Parts Kit #1