Specifications – Jacuzzi Luxury/Designer Bath Series K339000X User Manual

Page 5

Advertising
background image

ENGLISH

Important: Read complete instructions before beginning installation.

Each whirlpool bath arrives ready for installation, completely equipped with motor/pump assembly, heater, plumb-

ing, and fittings necessary for whirlpool operation. An optional drain/overflow kit is available for installation on the
bath.

Remove the bath from the carton. Retain the shipping carton until satisfactory inspection of the product has been

made. Do not lift the bath by the plumbing at any time; handle by the shell only.

Immediately upon receipt, inspect the shell before installing. Should inspection reveal any damage or defect in the

finish, do not install the bath. Damage or defect to the finish claimed after the bath is installed is excluded from the
warranty. Jacuzzi Whirlpool Bath's responsibility for shipping damage ceases upon delivery of the products in good
order to the carrier. Refer any claims for damage to the carrier. For definitions of warranty coverage and limitations,
refer to the published warranty information packed with the product.

All bath units are factory tested for proper operation and watertight connections prior to shipping. NOTE: Prior to

installation, the bath must be filled with water and operated to check for leaks that may have resulted from
shipping damage or mishandling.
Jacuzzi Whirlpool Bath is not responsible for any defect that could have been
discovered, repaired, or avoided by following this inspection and testing procedure.

DRAIN/OVERFLOW

A

B

SPECIFICATIONS

SIDE VIEW

END VIEW

H1

H2

2"

(51 mm)

H3

W

L

TORRETTA 36

(Heater)

(Motor)

MAX. 1/2"

SABELLA

L

H

(51 mm)

2"

(25 mm)

1"

W

SIDE VIEW

END VIEW

(Heater)

(Motor)

MAX. 1/2"

END VIEW

H

W

SIDE VIEW

L

4"

2"

ALLUSION

MAX 1"

(Heater)

(Motor)

(102 mm)

(51 mm)

5

Jacuzzi Whirlpool Bath K339000X 3/06

END VIEW

H

W

SIDE VIEW

L

1/2"

ELARA

(13 mm)

(Heater)

(Motor)

MAX. 1/2"

END VIEW

SIDE VIEW

2"

L

W

H

(Heater)

(Motor)

(51 mm)

BELLAVISTA

MAX. 1/2"

END VIEW

SIDE VIEW

(Heater)

(Motor)

CIPREA™, Right Hand

H

W

L

2"

(51 mm)

MAX. 1/2"

END VIEW

H

W

SIDE VIEW

L

2"

(Motor)

(Heater)

REÁL™, Right Hand

(51 mm)

MAX. 1/2"

Advertising