JVC HR-P111EE - Manual (Page 9)

9
1
2
1
2
Use the following procedure to record TV programmes on a
blank video tape.
Before proceeding:
•
To record TV programmes, the video cassette player must
be connected to the TV as shown in connection B of the
“Connections” section.
•
Turn on the power of the TV and video cassette player.
•
Make sure that the video cassette’s safety tab is intact. If it
has been removed, cover the hole with adhesive tape.
Recording
1
2
Load a blank video tape.
Press the Record ¶ ¶ ¶ ¶ ¶ button to start recording. (On the
remote control unit press the Record ¶ ¶ ¶ ¶ ¶ and Play 3 3 3 3 3
buttons at the same time.)
The recording indicator will light during recording.
7 Press the Stop/Eject § button or the remote control’s
Stop
7 7 7 7 7
button to stop recording.
To stop recording temporarily:
7
Press the Pause
8
button.
The recording indicator will blink.
Press the Play
3
button to resume recording.
Notes:
•
To engage recording standby, press the Record
¶
button
and then press the Pause
8
button. The recording indicator
will blink during recording standby. Press the Play 3 button
again to start recording.
•
If the Record ¶ button does not work, check to see if the
cassette safety tab has been removed.
•
The player automatically stops when record-standby
continues for more than 5 minutes.
•
The video tape will be rewound automatically when the end
of the tape is reached.
SCENE
FINDER SP/LP/EP NTSC
ON PAL TV
NTSC4.43 NTSC3.58
STANDBY OPERATE
LP/EP PAL NTSC B.E.S.T.
B.E.S.T. AUDIO
- TVCH +
- VOLUME +
TV/VIDEO
AUTO - TRACKING +
TV/VIDEO
OPERATE
VIDEO
OPERATE
REMOTE CONTROL UNIT
+ - (
L [ J
+ (
TV
2
Rewind power off
When the tape has finished rewinding, the VCR will turn itself
off.
During stop:
Press the Rewind
1
button.
Press the OPERATE button within 2 seconds.
The STANDBY indicator will blink.
Tracking adjustment
Automatic tracking is adjusted each time a cassette is inserted
in the video cassette player, you may wish to adjust tracking
manually during playback.
Manual tracking
Press the remote control’s AUTO button.
Press the remote control’s TRACKING + or – button to
adjust tracking.
7
Press the AUTO button to return to automatic tracking.
Notes:
•
Tracking may need to be adjusted each time a different video
tape is inserted for playback.
•
Tracking will be automatically set to the reference position
when the cassette is ejected.
Playback features (cont’d)
2 1