JVC XL-MV33BK - Manual (Page 19)

Page 16
XL-MV33BK/XL-MV55GD
LET0080-001A
VARIOUS UNIQUE FUNCTIONS
Using a wireless microphone
(only for XL-MV55GD)
A wireless microphone can be used with the XL-MV55GD player only.
Antenna preparations
You need to connect the FM antenna to the back of the player.
•
Open the FM antenna wire connectors by pushing them to the side,
insert the FM antenna wires, and close the connectors by pushing
them back into their original position.
• Attach the FM feeder antenna to the wall behind the player so that
the wire forms a “T” as illustrated.
(Rear panel)
Microphone operation
1. Insert the antenna cable into the end of the microphone as
illustrated and turn it clockwise to secure it.
3. Set the MIC SELECT switch to “WIRELESS”.
4. When the WIRELESS MIC button turns green, the wireless
microphone has been accepted. If the tuning is not proper
(noise or no voice output from the speaker because of interfer-
ence from TV signals etc.), the button turns red.
You can use up to four (4) microphones (3 wired and 1 wireless) at
the same time.
5. The wireless microphone voice is mixed into MIC 3. Wireless
microphone volume adjustment is performed with the MIC 3
knob.
WIRELESS
MIC ANT.
FM feeder antenna
Battery compartment cap
FREQ. ADJUST screw
MIC SELECT switch
OFF
WIRED
WIRE-
LESS
Antenna cable
* Be sure to set
the switch to
OFF when
you insert the
antenna cable.
2. Press the WIRELESS MIC button on the front panel.
Note
The maximum operating distance of the wireless microphone is about
10m. (This may change depending on room conditions.)
If there is interference when using the
wireless microphone
If the WIRELESS MIC button turns green in spite of the microphone
switch being off, or no voice is output from the speaker because of
interference from TV signals etc., continue with the next step.
Operation
1. Try to tune the microphone frequency. First, adjust the FREQ.
ADJUST screw in the rear panel using the provided screw-
driver, until the interference is gone.
(Rear panel)
FREQ.
ADJUST
2. Then set the MIC SELECT switch to “WIRELESS”.
3. While speaking into the microphone continuously turn the
microphone’s FREQ. ADJ screw with the provided screw-
driver until the WIRELESS MIC button on the front panel button
turns green.
Note
When you adjust the frequency, be sure to use the provided screw-
driver. Metal head screwdrivers may not adjust correctly or may
damage parts inside.
MIN MAX
MIC 3
WIRELESS
MIC
XL-MV33BK/XL-MV55GD
LET0080-001A
XL-MV33BK/55GD Body-1 97.5.27, 11:34 AM 16