Jack Lananne's Power Juicer SSMT1000 - Manual (Page 5)

DISASSEMBLY
5
Pusher
Filter
Blade
Crescent Tool
(for tightening and removing blade)
Receptacle
Juice Spout
Lip
Locking Bar
Screw Peg
Base
Pulp
Collector
PARTS LIST
(Crescent tool pegs fit here to tighten.)
(Pegs fit into blade.)
Lid with Pulp Guard
Pulp Guard
Chute
8
IMPORTANT: Before disassembling the unit
make sure you turn the power OFF and unplug
the machine from the electrical outlet.
Blade Lid with
Pulp Guard
Pulp
Collector
Locking Bar
2
MAIN UNIT
(Fully Assembled)
STEP 1:
Remove pusher from the chute. STEP 2:
Lower the locking bar (silver) into
position as shown.
Base
1
Pulp Guard
Pusher
4
STEP 3:
Remove lid with pulp guard, and pulp
collector. STEP 4:
Use the crescent tool (orange) to remove
the blade. Place the two pegs at either
end of the crescent tool into the two
holes on the blade, press down and turn
counter-clockwise to unlock the blade.
Remove blade carefully.
3
6
STEP 5:
Remove filter. STEP 6:
Make sure spout is in the upright
position to avoid leakage. Remove
receptacle from base.
5
Crescent Tool
Filter Receptacle