Joovy 43X Series - Manual (Page 4)

The Big Caboose Stand-On Triple Instruction Manual
Unfolding the Stroller
• Keep children away from stroller while unfolding.
• Position the stroller with the handle bar closest to you.
• Release the locking latch located on the right side by lifting the lever off of the extended rivet.
See Figure 2.
• Lift up slightly on the handle of the stroller. Then place one foot onto the rear platform and pull
up and back on the handle until both side frame bars snap into their locking positions in the
frame.
CAUTION: While unfolding the stroller, be careful to keep your fingers from being pinched by
moving parts.
• Lock BOTH safety latches on the lower left and right sides of the stroller by pushing the levers
down over the extended rivets. See Figure 3.
• Ensure that the stroller is completely opened and BOTH safety latches are secured before ANY
use of the stroller.
!
WARNING
ALWAYS secure the safety latches on the sides of the stroller when it is in
the unfolded use position. This will prevent collapse of the stroller should
the handle trigger locks be accidentally opened.
Figure 2 Figure 3
Installing the Rear Wheels
Please use the following component sequence that indicates how all the parts for the rear wheel
assembly are installed.
• Turn stroller upside down, on a clean surface, so that it rests on the handlebar.
• Insert one end of the rear wheel axle through a rear axle hole in the plastic bracket under the
stand-on platform.
Page 3 Page 4
Axle
Small
Washer
Wheel
Large
Washer
Spring
Washer
Snap
Pin
Hub
Cap
1 2 3 4 5 6 7 8
Large
Washer