Jabra BT530 - Manual (Page 6)

5
english
Jabra bt530
Turning your headseT on and off
- slide the on/off button forward on the side of the headset to
turn on the headset . the led will flash green for a second when
the headset is on .
- slide the on/off button backward to turn off the headset .
Pairing iT WiTh your Phone
headsets are connected to phones using a procedure called
‘pairing’ . by following a few simple steps, a phone can be paired
with a headset in a matter of minutes .
1. Put the headset in pairing mode
- When you turn on your Jabra bt530 for the first time, the
headset will automatically start up in pairing mode – i .e . it is
discoverable for your phone . When the headset is in pairing
mode the led is constantly lit .
2. Set your Bluetooth phone to ‘discover’ the Jabra BT530
- follow your phone’s instruction guide . first make sure that
bluetooth is activated on your mobile phone . then set your
phone to discover the headset . this usually involves going
to a ‘setup,’ ‘ connect’ or ‘bluetooth’ menu on your phone and
selecting the option to ‘discover’ or ‘add’ a bluetooth device .*
3. Your phone will find the Jabra BT530
- your phone will find the headset under name “Jabra bt530” .
your phone then asks if you want to pair with the headset .
accept by pressing ‘yes’ or ‘ok’ on the phone and confirm with
the passkey or PIn = 0000 (4 zeros) . your phone will confirm
when pairing is complete .
In case of unsuccessful pairing, put the Jabra bt530 into pairing
mode manually . make sure the headset is on . Press and hold the
answer/end button for approximately 5 seconds until the led has a
constant light . keep holding down the button until light is constant .