Setting the ta volume level, Automatic clock adjustment – JVC FSUN3117-312 KD-S8R User Manual

Page 17

Advertising
background image

17

ENGLISH

Changing the display mode while listening to an FM

station

You can change the initial indication on the display to station name (PS NAME), station
frequency (FREQ), or clock time (CLOCK) while listening to an FM RDS station.
• See also “Changing the general settings” on page 27.

1. Press and hold SEL (select) for more than 2 seconds to call up the general setting mode.
2. Press

¢ or

4 to select “DISPMODE (display mode).”

3. Set to the desired indication (station name, station frequency or clock time) with the control

dial.

Note:
By pressing DISP, you can also change the display while listening to an FM RDS station.
Each time you press the button, the following information appears on the display:

* Then, the display goes back to the original indication in several seconds.

Setting the TA volume level

You can preset the volume level for TA Standby Reception. When a traffic programme is
received, the volume level automatically changes to the preset level.
• See also “Changing the general settings” on page 27.

1. Press and hold SEL (select) for more than 2 seconds to call up the general setting mode.
2. Press

¢ or

4 to select “TA VOL (volume).”

3. Set to the desired volume level with the control dial.

Automatic clock adjustment

When shipped from the factory, the clock built in this unit is set to be readjusted automatically
using the CT (Clock Time) data in the RDS signal.
If you do not want to use automatic clock adjustment, follow the procedure below.
• See also “Changing the general settings” on page 27.

1. Press and hold SEL (select) for more than 2 seconds to call up the general setting mode.
2. Press

¢ or

4 to select “AUTO ADJ (adjust).”

3. Select “OFF” by turning the control dial counterclockwise.

Now automatic clock adjustment is canceled.

To reactivate clock adjustment, repeat the same procedure and select “ON” in step 3 by
turning the control dial clockwise.

Note:
It takes about 2 minutes to adjust the time using the CT data. So, you must tune to the station for more
than 2 minutes continuously; otherwise, the clock time will not be adjusted.

PS NAME (Station name)

PTY (Programme type)

FREQ (Station frequency)

CLOCK (Clock time)

EN10-17.KD-SX878R/S777R[E]/f

08/09/2000, 04:04 PM

17

Advertising
This manual is related to the following products: