Jensen DV354 - Manual (Page 2)

2
DV354
Introduction
Congratulations on your purchase of the JENSEN DV354 Mobile Multimedia DVD/CD/MP3 Player.
Features
• High temperature deck and OPU
• Slot type drive
• Front and rear AV jacks for system expansion
• Din size with mounting brackets included
• LCD display with blue back lighting
• Green back lit buttons
• Dolby digital sound
• IR remote control included
• 12 volt operation
• Compatible with PAL and NTSC DVD (Video CD)
• L/R stereo analog audio outputs for connection to existing head unit aux inputs
• Composite video output
Precautions
• Use the Proper Power Supply.
This product is designed to operate with a 12 volt DC, negative ground battery system (the
regular system in a North American car).
• Protect the Disc Mechanism.
Avoid inserting any foreign objects into the slot of this player. Failure to observe this may
cause malfunction due to the precise mechanism of this unit.
• Use Authorized Service Centers.
Do not attempt to disassemble or adjust this precision product; contact a professional for
assistance.
• Avoid Moisture.
To reduce the risk of fire or electric shock, do not expose this equipment to rain or moisture.
• Use Recommended Accessories:
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK AND ANNOYING INTERFER-
ENCE, USE ONLY THE RECOMMENDED ACCESSORIES.
CAUTION: This mobile DVD player is a Class I laser product that uses a visible/invisible
laser beam which could cause hazardous radiation exposure if improperly directed. Be
sure to operate the mobile DVD player as instructed. Use of controls or adjustments or
performance of procedures other than those specified herein may result in hazardous
radiation exposure. Do not open covers and do not attempt to repair the unit yourself. Refer
servicing to qualified personnel.
Preparation
It’s a good idea to read all of the instructions before beginning the installation. We recommend
having your JENSEN DV354 installed by a reputable installation shop.
Tools and Supplies
You will need these tools and supplies to install your DV354:
• Torx type, flat-head and Philips screwdrivers
• Wire cutters and strippers
• Tools to remove existing radio (screwdriver, socket wrench set or other tools)
• Electrical tape
• Crimping tool
• Volt meter/test light
• Crimp connections
• 18 gauge wire for power connections
• 16 – 18 gauge speaker wire
Disconnecting the Battery
To prevent a short circuit, be sure to turn off the ignition and remove the negative (-) battery cable
prior to installation.
NOTE: If the DV354 is to be installed in a vehicle equipped with an on-board drive or
navigation computer, do not disconnect the battery cable. If the cable is disconnected, the
computer memory may be lost. Under these conditions, use extra caution during
installation to avoid causing a short circuit.