JVC CA-UXE15 - Manual (Page 30)

27
To remove the speaker grilles
Troubleshooting
If you are having a problem with your System,
check this list for a possible solution before
calling for service.
General:
Adjustments or settings are suddenly canceled
before you fi nish.
@ There is a time limit. Repeat the procedure
again.
Operations are disabled.
@ The built-in microprocessor may malfunction
due to external electrical interference. Unplug
the AC power cord and then plug it back in.
Unable to operate the System from the remote
control.
@ The path between the remote control and the
remote sensor on the System is blocked.
@ Point it at the remote sensor on the font panel.
@ Signals cannot reach the remote sensor.
More closer to the System.
@ The batteries are exhausted.
No sound is heard from the speakers.
@ Speaker connections are incorrect or loose
(see page 7).
@ Headphones are connected (see page 9).
Radio Operations:
Hard to listen to broadcasts because of noise
(see pages 4 to 7).
@ Antennas connections are incorrect or loose.
@ The AM loop antenna is too close to the
System.
@ The FM antenna is not properly extended and
positioned.
Disc/USB Memory/DAP Operations:
The disc does not play.
@ The disc is placed upside down. Place the disc
with the label side up.
ID3 Tag on an MP3 cannot be shown.
@ There are two types of ID3 Tag—Version 1 and
Version 2.
This System can only show ID3 Tag Version 1.
MP3/WMA tracks do not play.
@ Track names have the initial letter “.”.
The disc sound is discontinuous.
@ The disc is scratched or dirty.
The disc cover does not open or close.
@ The AC power cord is not plugged in.
Timer Operations:
Daily Timer does not work.
@ The System has been turned on when the on-
time comes.
Timer starts working only when the System is
turned off.
Maintenance
To get the best performance of the System, keep
your discs, and mechanism clean.
Handling discs
• When removing the disc from its case, hold
it at the edge while pressing the center hole
lightly.
• Do not touch the shiny surface of the disc, or
bend the disc.
• Put the disc back in its case after use to
prevent warping.
• Be careful not to scratch the surface of the
disc.
• Avoid exposure to direct sunlight, temperature
extremes, and moisture.