JVC 0810YMH-AL-OT - Manual (Page 5)

5
Daily Maintenance
Be sure to turn off the power and detach the cables before performing any
maintenance.
Camcorder
 Wipe this unit with a dry, soft cloth to remove any dirt.
 When it is extremely dirty, soak the cloth in a solution of neutral
detergent, wipe the body with it, and then use a clean cloth to remove
the detergent.
CAUTION
•
Do not use benzene or thinner. (Cause of damage to or
malfunction of the unit)
•
When using a chemical cloth or other products, be sure to observe
the instructions of the product.
•
Do not leave the device in contact with rubber or plastic products
for a long time.
Lens/LCD
Monitor
 Use a lens blower (commercially available) to remove any dust, and a
cleaning cloth (commercially available) to wipe off any dirt. (Mold may
form if the lens is left dirty.)
 Perform [TOUCH SCREEN ADJUST] (P.45) if the reactive area of the screen
is misaligned with the touched area.
(Adjust by lightly tapping with a corner of an SD card, etc. Do not press
with an object with a sharp tip or do not press hard.)
 See page 27 for maintenance after recording in water. (GC-WP10 only)