JVC LST0420-001B - Manual (Page 26)

26
Adjusting Image
Ⅵ TK-C215V12 (continued)
‹ Registering alarm position
For registering the angle of view during
monitoring when there is an alarm input.
1. Check that the [ALARM POSITION]
indicator light is turned on.
Registration of alarm position is enabled.
● Press the [POSITION SELECT] button if the
[ALARM POSITION] indicator light is off.
2. Adjust the image size. ( A pg. 25)
3. Press the [MEMORY] button for 2 seconds
or longer.
The [ALARM POSITION] indicator light blinks
for 3 times (green)
ALARM position registration is completed
4. Adjust the brightness. ( A pg. 25)
5. Press the [POSITION SELECT] button.
The camera returns to the home position
NOTE:
● Be sure to return the camera to the home
position after registration of the alarm position
is completed.
In addition to pressing the [POSITION
SELECT] button, you can also use the power
ON/OFF button to return the camera to the
home position.
● To check images at the registered home
position or alarm position, press the
[POSITION SELECT] button. Press this
button to switch between the image at the
home and alarm positions.
Adjusting Images
(continued)
Ň
B
RESET/[SPOT]
LL
PHASE
R
WHT.BAL.
H
L
IRIS LEVEL
ZOOM/FOCUS FAR
WIDE
NEAR
POSITION SELECT
POSITION ALARM
[MEMORY]
2
4
1
2
3
4
5
6
7
8
TELE
4.
1.,5.
2.,3.
TK-C215V4_V12_EN.book Page 26 Wednesday, August 2, 2006 1:18 PM