JVC RX-E51B - Manual (Page 10)

6
Getting star
ted
Connecting the front, center, and surround speakers
Turn off all components before making connections.
1
Twist and remove the insulation at the end of each
speaker cord.
2
Press and hold the clamp of the speaker terminal
(1), then insert the speaker cord (2).
• For each speaker, connect the (+) and (–) terminals on the
rear panel to the (+) and (–) terminals marked on the
speakers.
3
Release the finger from the clamp.
CAUTIONS:
• Use speakers with the SPEAKER IMPEDANCE indicated by the
speaker terminals (6 Ω – 16 Ω).
• DO NOT connect more than one speaker to one speaker
terminal.
Connecting the speakers
Speaker Layout Diagram
Connecting the subwoofer
By connecting a subwoofer, you can enhance the bass or
reproduce the original LFE signals recorded in digital software.
Connect the input jack of a powered subwoofer to the
SUBWOOFER OUT jack on the rear panel, using a cord
with RCA pin plugs (not supplied).
• Refer also to the manual supplied with your subwoofer.
After connecting all the speakers and/or a subwoofer, set the
speaker setting information properly to obtain the best possible
surround effect. For details, see pages 14 to 17.
NOTE
You can place a subwoofer wherever you like since bass sound is
non-directional. Normally place it in front of you.
SUBWOOFER
OUT
2(VIDEO) 1(DVR/DVD)
DIGITAL IN
CENTER SURROUND
SPEAKERS
LEFT RIGHT LEFT RIGHT
FRONT
CAUTION: SPEAKER
IMPEDANCE 6 ~ 16 1 2
1 2 3
SW R L C RS LS
Right front
speaker (R)
Subwoofer (SW)
Center speaker (C)
Left front
speaker (L)
Right surround
speaker (RS)
Left surround
speaker (LS)
06-09RX-E5S[B]3.p65 04.1.13, 22:01 6