Recording, Recording basic recording – JVC MINI DV GR-DVL120 User Manual

Page 15

Advertising
background image

EN

15

RECORDING

Basic Recording

NOTE:

You should already have performed the procedures
listed below. If not, do so before continuing.

● Power (

pg. 8)

● Grip Adjustment (

pg. 10)

● Viewfinder Adjustment (

pg. 10)

● Load A Cassette (

pg. 12)

● Recording Mode Setting (

pg. 13)

1

Remove the lens cap.

2

Set the Power Switch to “

” or “

” while

pressing down the Lock Button located on the switch.
Shooting while using the LCD monitor: Make sure
the LCD monitor is fully open. Tilt it upward/
downward for best viewability.
Shooting while using the viewfinder: Close the
LCD monitor.
• The power lamp lights and the camcorder enters the

Record-Standby mode. “PAUSE” is displayed.

3

Press the Recording Start/Stop Button. “

appears while recording is in progress.

To Stop Recording . . .

..... press the Recording Start/Stop Button. The

camcorder re-enters the Record-Standby mode.

To Adjust The Brightness Of The Display . . .

..... rotate the MENU/BRIGHT wheel until the bright

level indicator on the display moves and the
appropriate brightness is reached.

NOTES:

● If the Record-Standby mode continues for 5 minutes,

the camcorder’s power shuts off automatically. To turn
the camcorder on again, set the Power Switch to
“OFF”, then back to “

” or “

”.

● The image will not appear simultaneously on the LCD

monitor and the viewfinder. It will appear in the
viewfinder when the LCD monitor is in the lock position,
and it will appear on the LCD monitor when fully
extended.

● When a blank portion is left between recorded scenes

on the tape, the time code is interrupted and errors may
occur when editing the tape. To avoid this, refer to
“Recording from the middle of a tape” (

pg. 18).

To turn the beep sounds off,

pg. 32, 34.

25

min

BR I GHT

90 min

89 min

3 min

2 min

1 min

0 min

min

Power lamp

Lock Button

Recording Start/Stop Button

Tape remaining time
indicator (Approximate)

(Now calculating)

(Blinking)

(Blinking)

(Blinking)

Display

MENU/BRIGHT Wheel

Power Switch

PUSH OPEN Button

During

shooting

For other notes,

pg. 47

Advertising