Jackson Automobile Battery Charger - Manual (Page 4)

3.0 BELT DRIVES
3.1 NOTE: CARS WITH POWER STEERING:
Use a 12mm socket and combination wrench to
loosen the power steering slide lock bolt. Then
loosen the tensioning bolt. Use a 14mm deep
socket and combination wrench to loosen the
power steering pivot bolt. You may have to rotate
the pulley to access this bolt. Using a 14mm
socket loosen and remove the slide anchor bolt
at the engine. At this point the power steering
pump should be able to pivot. Push the pump
downward towards the air conditioning compres-
sor and remove the belt. Now, use a 12mm sock-
et to remove the bolt securing the power steering
hose to the bracket. Using a 14mm socket,
remove the two bolts securing the power steering
bracket to the power steering pump. Remove the
whole tensioning system including the tensioning
and power steering brackets. Then, remove the
nut from the power steering pivot bolt. Illustration
3.1
3.2 Gather together the new belt tensioner
assembly, the new power steering hose support
bracket and the supercharger strap bracket.
Using a 22mm combination wrench slightly
loosen the power steering hose on the top of the
power steering pump and swing the hose to clear
the new power steering hose support bracket.
Then install the new hose support bracket in the
same place as the factory bracket. Temporarily
install the upper bolt to help with alignment.
Tighten the bottom bolt to 36 ft lbs. Once the bot-
tom bolt is tight, remove the upper bolt. Now,
slide the power steering pivot bolt rearward out of
the pump. It will be reinstalled from the front.
Remove the rubber sleeve holding the short-
headed bolt in the new tensioner assembly. Slip
the new tensioner assembly into place behind the
power steering pulley, aligning its lower hole with
the pivot bolt hole. Reinstall the pivot bolt (from
the front). The bolt may come in contact with the
radiator cooling fan. It this occurs, the fan can be
depressed a slight amount to allow the bolt by or
use a 10 mm socket to remove the two bolts
securing the fan to the radiator and slide it up to
allow the bolt to be installed. Install the short-
headed bolt again just above the pivot bolt. It
should thread into the cast power steering brack-
et, bolted to the engine. Finally, install the last
bolt through the tensioner assembly and through
the power steering hose support bracket into the
upper hole in the pump. Slide the round hole of
the strap bracket onto the end of the pivot bolt on
the back side of the power steering pump and
start the flanged nut. Tighten the two upper bolts
on the tensioner assembly, securing it to the
power steering pump and the cast power steering
bracket, bolted to the engine. Tighten to 36 ft lbs.
The power steering pump pivot bolt will stay
loose until the supercharger is installed.
Supercharger Installation Instructions
999-156, 999-157, 999-158 & 999-159 -4- Revised 06/08
Illustration 3.1
Slide anchor
bolt
Slide lock
bolt
Tensioning
bolt