Jensen JCR-540 - Manual (Page 6)

E-6
TIME SETTING
In order for the clock to function properly, the clock has to be set the first time you use the unit.
After powering up the unit, the clock display will show “12:00”. To set the time, follow the steps below:
1. Press and hold the TIME Button.
2. Press the HOUR Button repeatedly and release until the correct hour is displayed.
Note:
Make sure the hour is set so that AM or PM is correctly displayed. There is a PM
Indicator located in the left bottom corner of the lower LCD. If the PM Indicator lights the
displayed time is “PM”. If the PM Indicator does not light, the time displayed is “AM”.
3. Press the MINUTE Button repeatedly and release both the TIME and MINUTE Buttons until the
correct minute is displayed.
CD PLAYER OPERATION
Note:
This CD player will play not only commercial CDs, but also the self-compiled CD-R/RW discs. Do
not attempt to play CD-ROM, CDI, VCD, DVD or computer CDs.
Notes on CD-R/RW Discs
• Because of non-standardized format definition/production of CD-R/RW, playback quality &
performance are not guaranteed.
• Manufacturer is not responsible for the playability of CD-R/RW due to recording conditions such
as PC performance, writing software, media ability, etc.
• Do not attach a label or seal to either side of the CD-R/RW disc. It may cause a malfunction.
1. Set the Function Selector (# 21) to the "CD" position.
2. To power on the unit, press the Button. The POWER Indicator will light.
3. Press the PUSH OPEN Button to open the CD Door.
4. Load an audio CD with its label side facing out and close the CD Door. A click sound will be heard
indicating the CD Door is firmly locked.
5. “- -” will appear and blink in the upper Display. After a few seconds, the total number of tracks on
the CD will appear in the Display.
6. Press the Button once then the CD will start playing from the first track. Track No. “01” will be
shown steadily in the Display.
7. Adjust the VOLUME Control to obtain the desired sound level from the Speakers.
8. To suspend playing, press the Button. The Track No. “01” will flash. To resume playing, press the
Button again.
9. You can choose to play your favorite track directly by pressing the Skip Forward Button to skip
forward or the Skip Back Button to skip backward. The track number of the selected track will
be shown in the Display.
10. To repeat the current playing track, press the REPEAT Button until icon “
1
“appears in the left top
corner of the Display.
11. To repeat the entire CD, press the REPEAT Button until icon “ ” appears in the left top corner
of the Display. Press the REPEAT Button again to resume normal playback.
12. To stop playing, press the STOP
■
Button.