JVC SR-VD400E - Manual (Page 44)

44
EN
JLIP ID Number
Setting
The JLIP (Joint Level Interface Protocol) terminal is used to
connect the VCR to a personal computer or similar device.
By connecting through the JLIP terminals, you can control
the VCR during editing and certain other operations, from
the connected personal computer or similar device.
When connecting this VCR to another device using the
JLIP terminals, each device must have a different JLIP ID
number.
The JLIP ID number of this VCR is preset to “1” when
shipped from the factory. You can change this number to
any other number between 1 to 99.
To change the JLIP ID number of this VCR, follow the
procedure below.
1 Access Main Menu screen
Press [MENU].
2 Select JLIP ID Set Up screen
1 Press [ @ #] to move the arrow to “INITIAL SET
UP”, then press [ fi] or [OK].
2 Press [ @ #] to move the arrow to “OTHER”,
then press [ fi] or [OK].
3 Set JLIP ID Number
Press [ %fi] to move
the arrow to “JLIP
ID”.
Press [
@ #] to enter
the desired ID
number.
4 Return to normal screen
Press [MENU].
● Turn on the VCR and the TV, and select the AV mode
on the TV.
● Set the [VCR/TV/CABLE/DBS] selector on the Remote
to [VCR].
VCR
TV
CABLE
/DBS
1 4
2 3
FUNCTION SET UP INITIAL SET UP
THEN PRESS [OK]
CLOCK SET
JLIP ID
LINC
RESET NUMBER
1
OTHER
SELECT WITH ARROW KEYS
AUTO
SELECT
OK
EXIT
MENU
OTHER USEFUL FUNCTIONS (cont.)