JVC LVT1248-002A - Manual (Page 3)

English
3
Before assembling—
• Prepare a Phillips screwdriver.
• Place a large, thick cloth on the floor where you assemble the
speaker stand to protect the floor and the speaker stand.
7
Assembling the speaker stand
• Tighten the screws firmly so that no space is left between
the legs and plates.
1 Fix the top plate.
• Align the projection of the legs to the holes of the top plate
correctly, then attach them with three of the supplied
screws B (M6 x 16 mm).
* The side without spacer should face outside.
2 Fix the bottom plate and leg holders.
• Align the projection of the legs to the holes of the bottom
plate correctly, then attach them with three of the supplied
screws A (M6 x 30 mm).
3 Finally tighten screws A and B fully.
• Tighten them firmly and fully so that no space is left between
the legs and plates.
7
Attach the speaker on the stand
1 Locate the speaker properly by aligning both screw holes
of the speaker and the speaker stand.
• Do not install the speaker stand on an uneven surface or in
a place subject to vibration.
• Do not install any overweight equipment (over 10 kg) on the
speaker stand.
2 Fix the speaker with the supplied screws C (M5 x 28 mm).
• Do not overtighten the screws, but firmly enough to prevent
the speakers from being shaky.
Assembly Installing Speaker
Leg B (thin)
Screws A
(M6 x 30 mm)
Spacer
Bottom plate
Leg A (thick)
Spacer
Leg holder
Thick cloth
(not supplied)
Screw C (M5 x 28 mm)
Spacer
Screws B
(M6 x 16 mm)
Top plate
Leg B (thin)
Leg A (thick)
330 260
632 585
15
30
2
Unit: mm
Design and specifications subject to change without notice.
Mass: 5.3 kg each
Maximum load: 10 kg
Dimensions: See the diagram.
Specifications
EN_LS-M1[US]4.p65 04.11.4, 4:57 PM 3