JVC KD-LX555R - Manual (Page 6)

6
ENGLISH
LVT1008-001A [E/EX]
Preparing the remote
controller
Before using the remote controller:
• Aim the remote controller directly at the remote
sensor on the main unit. Make sure there is no
obstacle in between.
• Do not expose the remote sensor to strong
light (direct sunlight or artificial lighting).
Installing the battery
When the controllable range or effectiveness of
the remote controller decreases, replace the
battery.
1. Remove the battery holder.
1) Push out the battery holder in the direction
indicated by the arrow using a ball-point
pen or a similar tool.
2) Remove the battery holder.
2. Place the battery.
Slide the battery into the holder with the +
side facing upwards so that the battery is
fixed in the holder.
3 . Return the battery holder.
Insert again the battery holder pushing it until
you hear a clicking sound.
WARNING:
• Store the battery in a place where children
cannot reach.
If a child accidentally swallows the battery,
consult a doctor immediately.
• Do not recharge, short, disassemble or heat the
battery or dispose of it in a fire.
Doing any of these things may cause the battery
to give off heat, crack or start a fire.
• Do not leave the battery with other metallic
materials.
Doing this may cause the battery to give off heat,
crack or start a fire.
• When throwing away or saving battery, wrap it
in tape and insulate; otherwise, the battery may
start to give off heat, crack or start a fire.
• Do not poke the battery with tweezers or similar
tools.
Doing this may cause the battery to give off heat,
crack or start a fire.
CAUTION:
Do not leave the remote controller in a place (such
as dashboards) exposed to direct sunlight for a
long time. Otherwise, it may be damaged.
(back side)
Remote sensor
(back side)
Lithium coin battery
(product number:
CR2025)
1)
2)
KD-LX555R
10 9 11 12
OFF INT RPT RND
EN04-06KD-LX555R[E]f.p65 02.12.11, 16:13 6