Jensen JXM900B - Manual (Page 6)

128-7377
6 of 16
-6-
1. Turn the Boom Box upside down to access
the battery compartment.
2. Push the battery cover latches forward and flip
up the battery compartment cover to the open
position.
3. Insert eight (8) C-Cell batteries observing
battery polarity as shown; then close the cover.
3. Installing the Receiver in the JXM900B
Install the receiver as follows:
IMPORTANT: Make sure boom box power is off before
installing and removing the JXM900R
Receiver.
a. Press the EJECT button at the top of the JXM900B;
the spring-loaded mounting plate will tilt forward.
Carefully line up the receiver rear spine grooves
with the guide spines on the mounting plate; gently
push the receiver down onto the plate.
2. Cabling Interconnections
You can begin to enjoy XM® Satellite Radio as soon
as the Receiver and Boom Box Kit installation are
complete. Set up your Audiovox JXM900B by following
the interconnect diagram.
NOTE: The batteries are bypassed automatically
whenever the supplied AC Adapter is
plugged into the DC 12V jack on the back
panel.
1. Battery Installation
Your Boom Box can operate independently of AC
power by installing 8 C-Cell batteries as follows:
RECEIVER
REAR VIEW
RECEIVER
REAR SPINE
GROOVES
BATTERY
COMPARTMENT
COVER
BOTTOM OF
BOOM BOX
COVER LATCHES
BATTERY
COMPARTMENT
(COVER REMOVED)
NEGATIVE
POSITIVE
NEGATIVE
POSITIVE