GE RM94931 - Manual (Page 3)

3
SETUP
Battery Installation
1. On the back of the remote, push down on the
tab and lift the cover off.
. Match the batteries to the + and - marks inside
the battery case, then insert  AAA Alkaline
batteries.
3. Press the battery cover back into place.
Battery Saver
Your remote automatically turns off if the buttons
are depressed more than 30 seconds. This will
save your batteries should your remote get stuck in
a place where the buttons remain depressed (e.g.,
between the sofa cushions).
Code Saver
You will have up to 10 minutes to change the
batteries in your remote without losing codes you
have programmed. However, do not press any
buttons until batteries are installed in the remote.
If buttons are pressed without batteries in the
remote, all codes will be lost.
Code Setup
The SETUP button is used to setup the remote.
You can either setup the remote using the code
tables (on separate sheet), or you can search
through the library of codes until you find a code
that works for your product. Please refer to “ Code
Search” on page 8 for more information on using
the code search feature to learn how to search
through the library of codes for your products.
NOTE: You can store any kind of code under any
mode (except TV). I.E. you can store a VCR code
under the CBL/SAT button, or a Cable code under
the DVD/AUX button, etc. However, you can only
store TV codes under the TV button.
Setup