JVC HI-FI HR-J748EH - Manual (Page 36)

36
EN
TV Multi-
Brand Remote
Control
SPECIAL FEATURES
Your remote control can operate the basic functions of your TV set.
In addition to JVC TVs, other manufacturer’s TVs can also be
controlled by setting the appropriate switch on the remote control.
Before you start . . .
● Turn on the TV using its remote control.
● Set the remote control’s TV/SAT./VCR switch to TV.
TV BRAND NAME CODE
JVC 01, 02, 03, 04
BRANDT 05
NORDMENDE 05
SABA 05
TELEAVIA 05
TELEFUNKEN 05
THOMSON 05
FERGUSON 06
PHILIPS 07
BLAUPUNKT 08
GRUNDIG 08
SONY 09
PANASONIC 10
GRAETZ 11
ITT 11
LUXOR 11
SALORA 11
SELECO 11
MIVAR 12
HITACHI 13
TOSHIBA 14
MITSUBISHI 15
FINLUX 16
NOKIA 17
SHARP 18
FUNAI 20
NEC 22
Control Your TV Using
Additional Buttons
The NUMBER keys on the remote can also be used to select
the TV’s channel by setting the remote control to the TV mode.
1 Set the TV/SAT./VCR switch to TV.
2 Use the NUMBER keys, and the (Digit Entry)
button, the PUSH JOG button, the DISPLAY button or
the OK button to select the TV’s channel.
● With televisions under Code 01, 02, 03, 04, 06, 07, 09,
10, 13, 14 or 22, the button corresponds to the 1-
digit/2-digit entry switching button (often labelled – /– –)
of your TV’s remote control.
● With televisions under Code 01, 11 or 12, the PUSH JOG
button corresponds to the 10 + button, and the PUSH
JOG button corresponds to the 20 + button of your TV’s
remote control.
● With televisions using Code 12, the DISPLAY button
corresponds to the 30 + button.
● With televisions using Code 09, the OK button corre-
sponds to the ENTER button of your TV’s remote control.
NOTE:
The way these buttons are used is determined by your TV.
Use these buttons as instructed for your TV’s remote control.
fi
%
1 2
4 5
3
6
8
0
7 9
2
4
1
3 OK
TV PROG.
STOP
PUSH JOG
NUMBER
DISPLAY
SET TV BRAND CODE
1
Refer to the chart below. While holding down ,
enter your TV’s brand code using the NUMBER keys,
then press STOP.
● JVC has four codes. If the TV does not function with
one code, try entering another.
● You don’t have to repeat this step until you replace
your remote control’s batteries.
TRY OPERATING TV
2
Press on the remote to turn the TV off. If it goes off,
try other operations.
● The button, TV/VCR button, TV PROG. +/–
button, TV VOL. %fi button and (Mute) button
on the remote can all be used to operate the TV.
● To return the remote to video recorder control, set its
TV/SAT./VCR switch to VCR.
IMPORTANT
Although the provided remote control unit is compatible with
JVC televisions, as well as many other models, it may not work
with your TV, or in some instances, may have limited function
capability.
TV/VCR
TV/SAT./VCR
TV VOL. %fi