JAI CV-L105 - Manual (Page 16)

CV-L105
7. Configuring the Camera
All configuration of the CV-L105 camera is done via the RS-232C port, which is factory setting.
Binning and pixel rate settings can also be controlled by TTL signals into the interface connector
or internal jumpers. From the factory, the camera will start up with the factory default.
The factory setting is as follows:
Clock 30 MHz
Binning 2048 (Off)
Trigger Internal
Mode Scan
Scan time 32.350 msec
RGB gain and offset To 3100K color balance (by internal potentiometers)
The factory settings cannot be changed by user.
There are 4 user defined configurations, which can be programmed by RS-232C and used as
initial default settings.
7.1. RS-232C control.
Communication setting.
Baud Rate 9600 bps
Data Length 8 bit
Start Bit 1 bit
Stop Bit 1 bit
Parity None
Xon/Xoff Control
None
RS 232C cable TXD
RXD
GND
1 CD
4 DTR
6 DSR
2 RXD
3 TXD
5 GND
7 RTS
8 CTS
9 CI
9 pin
D-con
PC COM
PORT
CAMERA
TXD
RXD
GND
1 CD
4 DTR
6 DSR
2 RXD
3 TXD
5 GND
7 RTS
8 CTS
9 CI
9 pin
D-con
PC COM
PORT
CAMERA
Fig. 16. RS-232C cable.
JAI provides a comprehensive software configuration tool, to configure the different functions of
the camera.
The CV-L105 Camera Control Tool for Windows 98/NT/2000 can be downloaded from
www.jai.com (For not released versions only from JAI Partner Site).
The control tool contents a camera control program and tools for making your own program. The
program has a help function, which describes functions, and make it easy to use.
Fig. 17. Camera Control Tool
For the integrator and experienced user, the Camera Control Tool is much more than a program
with a window interface- It also provides an easy and efficient ActiveX interface built for MS
Windows 98, ME, NT and 2000. The OCX interface has the ability to connect to the camera using
the serial interface of the PC by reading and writing properties for the camera. This integration
requires simple programming skills within Visual Basic, Visual C++ or similar languages in a
Microsoft Windows environment.
- 15 -