JVC DT-V100CG - Manual (Page 16)

16
How to Use SET-UP MENU
(cont.)
COLOR TEMP./BAL.
Sets or adjusts the color
temperature or white
balance.
NOTE:
Use the five items indicated with
mark to make fine adjustments
between the monitors.
Ⅵ COLOR TEMP.
Selects the color temperature.
HIGH: Sets the color temperature to 9300.
LOW: Sets the color temperature to 6500.
Ⅵ BLUE DRIVE
Adjusts the blue drive level.
• MIN O 000 O MAX (in 127 grades)
Ⅵ RED DRIVE
Adjusts the red drive level.
• MIN O 000 O MAX (in 127 grades)
Ⅵ GREEN CUTOFF
Adjusts the green cut-off point.
• MIN O MAX (in 155 grades)
Ⅵ BLUE CUTOFF
Adjusts the blue cut-off point.
• MIN O MAX (in 155 grades)
Ⅵ RED CUTOFF
Adjusts the red cut-off point.
• MIN O MAX (in 155 grades)
Ⅵ HOUR METER X100h
Displays the total usage time of the monitor in
hundred-hour units.
• 000 O 655
NOTES:
• When the timer passes 655, it returns to 000.
• The timer does not count the usage time under one hour.
PICTURE SUB ADJ.
The standard value (“00”) of
the picture adjustment is
initially set at the factory.
You can adjust the standard
value as your initial setting.
• Can also be used to switch the
NTSC set-up level, and
change the component or SD
SDI signal’s input level
settings.
Ⅵ CONTRAST
• –20 O 00 O +20
Ⅵ BRIGHT
• –20 O 00 O +20
Ⅵ CHROMA
• –20 O 00 O +20
Ⅵ PHASE
• –20 O 00 O +20
Ⅵ NTSC SETUP
Sets the set-up level of the input NTSC signal.
00: Compliant with 0% set-up signal.
7.5: Compliant with 7.5% set-up signal.
Ⅵ COMPO. LEVEL
Sets the set-up level of the input component or SD
SDI signal.
This item appears on the menu only when using the
Multi-Format SDI Unit (option) or the Component Unit
(option).
SMPTE: Compliant with M2VTR signals.
B00:
Compliant with Betacam 0% set-up signal.
B75: Compliant with Betacam 7.5% set-up signal.
EN14-24_LCT1811-001A-H.p65 05.5.13, 1:18 PM 16