Preparation, Tools and supplies, Choosing a mounting location – Jensen Tools MCD4030 User Manual

Page 3: Preparación, Herramientas y provisiones, Elección del lugar para la instalación, Préparation, Outils et matériel, Choisir un emplacement de montage, Mcd4030

Advertising
background image

MCD4030

3

Preparation

Tools and Supplies

The following tools and supplies are needed to install the unit.

•

Torx type, Flat and Phillips screwdrivers

•

Wire cutters and strippers

•

Tools to remove existing radio (screwdriver, socket wrench set or other tools)

•

Electrical tape

•

Crimping tool

•

Volt meter/test light

•

Crimp connections

•

18 gauge wire for power connections

•

16-18 gauge speaker wire

Speaker Requirements: Only connect speakers rated in the load impedance of 4 ohms. Speakers
with a load impedance less than 4 ohms could damage the unit.

Choosing a Mounting Location

The following tips will help you determine the best location for mounting the unit:
•

Select a location that does not interfere with the normal functions of the driver and will not
cause injury to the driver or a passenger in the event of a sudden stop or other emergency.

•

Do not install the unit in a location that would subject it to high temperatures (such as in
direct sunlight or next to a heating unit), dust, dirt or excessive vibration.

•

Install the unit in a horizontal position if at all possible. If the installation angle exceeds 30
degrees from the horizontal, the unit may not function optimally.

•

If the installation requires the drilling of holes or other vehicle modifications, consult the
nearest dealer for assistance.

•

Before completing installation of the unit, connect the wiring temporarily to ensure that the
unit operates properly in the selected mounting location.

Preparación

Herramientas y Provisiones

Las siguientes herramientas y provisiones son necesarias para instalar el radio:

•

Llave torx, destornilladores plano y Phillips

•

Cúter y peladores de cables

•

Herramientas para remover la radio existente (destornillador, equipo de llave de casquillo y
otras herramientas)

•

Cinta aisladora

•

Enganchador

•

Voltímetro / luz de prueba

•

Conexiones para enganchar,

•

Cable de calibre 18 para conexiones eléctricas, cable de altoparlante de calibre 16w[TJeeVgTDbre 1697.8( to hs[TJeeV 97.ueri)-7.5oslonexi4(voz: Solame7.5(dentep)14.erl5(existe2105nexi)]TJ16.3383 0 TD0d)-stric-6.7-7.4(s)4vo[(l)4.5( other-7(l)4.ime)-7.4(ud5.3i(l)4 in the4-7.6(t)-0.2105nha)-8(dor)]TJ0 -1.2556 TD0.0005 ohTw[(•ms. Alt, cable de34vo[Tw[(•sp)14iona.5( s p)15g(l)4.imeeda.3i(lm[Tw[(•nir)ad)-st4 ohm(C)ued5. daTw[(•ñaa)-0.on dad-7.4(6)-14.8(ación)]TJ/TT4 1 T4.92539.1.98 37.62-1.2556 TD375 TD0E4(e)n)-04.8(l)4ltLu-19nIns9n09noltil

Advertising