Jabra BT 350 - Manual (Page 5)

En
gli
sh
5
En
gl
is
h
4
5
4
2
3
Make a call
• When you make a call from your mobile phone, the call will (subject to phone
settings) automatically transfer to your headset . If your phone does not support this
function, tap on the answer/end button on the Jabra BT350 to receive the call in the
headset .
Reject a call*
• Press the answer/end button when the phone rings to reject an incoming call .
Depending on your phone settings, the person who called you will either be
forwarded to your voice mail or hear a busy signal .
Activate voice dialing*
• Tap the answer/end button . For best results, record the voice-dialing tag through
your headset if your phone allows you to do so . Please consult your phone’s user
manual for more information about using this feature .
Redial last number*
• Press the answer/end button .
Adjust sound and volume
• Press the volume up or down (+ or -) to adjust the volume .
• To mute, press both volume up and down at the same time . A low beep alert plays
during a muted call .
• To un-mute, tap either of the volume buttons .
Call waiting and placing a call on hold*
This lets you put a call on hold during a conversation and answer a waiting call .
• Press the answer/end button once to put the active call on hold and answer the
waiting call .
• Press the answer/end button to switch between the two calls .
• Tap the answer/end button to end the active conversation .
Call vibrate*
• Call vibrate is automatically activated when you turn on your headset .
• To disable the call vibrate feature, press the answer/end button and press the
volume down (-) button at the same time .
• To reactivate the call vibrate feature, press the answer/end button and press the
volume up (+) button at the same time .
* Dependent on your phone supporting this function . Please check your phone’s
user manual for further details
Turning your headset on and off
• Press the answer/end button to turn on your headset .
• Press and hold the answer/end button to turn off your headset .
Pair it with your phone
Before you use your Jabra BT350, you need to pair it with your mobile phone.
1. Put the headset in pairing mode
• Make sure the headset is off .
• Press and hold the answer/end button until a solid blue light comes on .
2. Set your Bluetooth phone to ‘discover’ the Jabra BT350
Follow your phone’s instruction guide . This usually involves going to a ‘setup,’
‘connect’ or ‘Bluetooth’ menu on your phone and selecting the option to ‘discover’ or
‘add’ a Bluetooth device .* (See example from a typical mobile phone in fig. 5)
3. Your phone will find the Jabra BT350
Your phone then asks if you want to pair with it . Accept by pressing ‘Yes’
or ‘OK’ on the phone and confirm with the passkey or PIN = 0000 (4 zeros).
Your phone will confirm when pairing is complete . In case of unsuccessful pairing,
repeat steps  to 3 .
Wear it how you like it
The Jabra BT350 is ready to wear on your right ear . If you prefer the left, gently flip and
rotate the ear hook 80° . See fig 3 .
For optimal performance, wear the Jabra BT350 and your mobile phone on the same
side of your body or within line of sight . In general, you will get better performance
when there are no obstructions between your headset and your mobile phone .
How to…
Answer a call
• Tap the answer/end button on your headset to answer a call .
End a call
• Tap the answer/end button to end an active call .