Jaguar 2002MY NAS Audio System JJM 18 03 24/22 - Manual (Page 10)

Controls and operation 2-3
DSP Setting Seating Positions
With a mode selected, adjust the volume
control knob to the desired level.
After approximately five seconds the
audio system will return to normal
volume control mode.
Digital Signal Processing – DSP
(S-TYPE Premium Audio System only)
DSP facilitates optimisation of sound for
specific seating positions. To optimise
sound for all seating positions:
1. Repeatedly press the MODE button
until POS ALL is displayed.
2. Rotate the volume control knob to
cycle through POS F-LEFT (front left),
POS F-RIGHT (front right),
POS REAR, and POS FRONT until
the desired setting is achieved.
Following approximately five seconds of
no further actions or adjustments, the
audio system will return to the previous
display.
Mode level 2
Press and hold MODE button until
TA VOLUME is displayed, then
repeatedly press and release to scroll to
the following displays as required:
• VOICE (adjust Voice Activation
volume).
• VOICE TRAIN A.
• VOICE TRAIN B.
• CLOCK SET.
Press and hold MODE button to exit.
Setting the audio display clock
1. Press and hold the MODE button
until TA VOLUME is displayed.
2. Repeatedly press and release the
MODE button until CLOCK SET is
displayed.
3. While the hour format is flashing, use
the seek up/seek down keys to select
either 12 or 24 hour format.
4. Press and release the MODE button.
5. If the 12 hour format has been
selected, use the # key to select AM
or PM as appropriate.
6. Using the keypad, enter the correct
time. It should be noted that clock
time must be entered as four digits
e.g. 0325 or 1525, when in 12 or
24 hour format.
7. To exit clock setting procedure, press
and hold the MODE key until the
display reverts to audio mode.